AMD LASERS Monet Laser Curing Light User Guide
- June 5, 2024
- AMD LASERS
Table of Contents
AMD LASERS Monet Laser Curing Light
QUICK START GUIDE
LIGHT STATUS
This example of cure time is using an A2 Composite material.
| Composite Depth | Curing Cycle | With Attenuator |
|---|---|---|
| 2mm or less | 1 sec | Yes |
| 2 – 3mm | 1 sec | No |
| 3 – 5mm | 2 sec | No |
| 5mm or more | 3 sec | No |
Use QR code to see a full matrix of recommended cure times with many brands of composite
Radiometer Check
- Place Monet lens directly on sensor
- Initiate Monet Laser
- See results: Low (orange) Borderline
(Yellow) Good (Green)
Note: Radiometer is tuned for the full, unobstructed output of the unit.
Scan & Watch Video
Hosted by Mike DiTolla amdlasers.com/pages/monet-setup-guide
For more information see Owners Manual.
For additional Help contact Customer Service:
1.866.999.2635 | support@amdlasers.com
© 2021 AMD Lasers, Inc. All Rights Reserved. 05019.v06.21
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>