SP CONNECT 4120761 All-Round LED Light 200 User Manual
- June 5, 2024
- SP CONNECT
Table of Contents
SP CONNECT 4120761 All-Round LED Light 200
Charging the All-Round LED Light 200
- Connect the provided USB cable to the Micro-USB port [C] and a suitable USB power source.
- The charging process starts when the LED [B] is lit red.
- Charging is complete when the LED [B] turns green.
- It takes approx. 2 hours to fully charge the All-Round LED Light 200.
Power On/Off [A] and Light Modes
- Turn it on by pushing the power button [A] for 1 second.
- Shortly press the power button [A] to switch through light modes, as shown on page 3.
- Turn o by pushing the power button [A] for 1 second.
- When the All-Round LED Light 200 is switched o and on, it will return to the last used light mode.
- If batteries were emptied fully before recharging, the All-Round LED Light 200 will start at mode 1 (75 Lumen).
- If battery power is critically low in any of the 3 modes. LowBatteryFlash will start automatically and work for at least 30 minutes.
Battery LED
When turning on the light or changing mode, the battery LED will light up
- green: 40 – 100% charged
- orange: < 40% charged
- red: 30 minutes or less remaining (LowBatteryFlash)
Mounting instructions
- Turn 90° clockwise to lock and 90° counter-clockwise to unlock and remove
- Place the light on Micro-rails and gently press down
All-Round LED Light 200
- An On/Off Button
- Charge LED
- Micro USB port
Specifications
- Battery Voltage: 3.7V
- Battery capacity: 1.37Wh, 370mAh
- Luminous flux [lm] 75 – 275 lm
- Input: 5V, 500mA
- Working temperature: -20–40°C / -4–104°F
- Working humidity: 30–95% RH
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>