CHCNAV LT60H GNSS Data Controller User Guide
- June 3, 2024
- CHCNAV
Table of Contents
CHCNAV LT60H GNSS Data Controller
Introduction
This user guide describes in detail how to install, configure and use the LT60H; the description of the operation process is clear and simple, so that users can easily, quickly and accurately get familiar of this controller.
Experience requirements
In order to be able to use LT60H better, CHCNAV recommends to read this user
guide carefully before using this product. If you are not familiar with the
LT60H principle, please contact support@chcnav.com for more details.
Disclaimer
Before using this product, please make sure you read the user guide carefully
for better use of this product.CHCNAV will not be responsible for any damage
caused by the operation without following the requirements of this document,
or the misuse of this document without proper understanding of the
requirements of this document; however, we will strive to continuously improve
the functions and performance of the product, improve the quality of service,
and reserve the right to change, optimize and improve the content of the
instruction manual, and regularly inform the content in the form of upgrade
release. Please pay attention to the latest information released on our
official website (www.chcnav.com).
Your suggestions
If you have questions, you can contact local supplier or send email to support@chcanv.com
Introduction
CHCNAV LT60H is a high-performance intelligent handheld terminal developed by Shanghai Huace Navigation Technology LTD. The LT60H incorporates powerful navigation features with improved sensitivity, helping to achieve more accurate and faster location services. Powered by Android 12.0 OS with 2.0GHz quad-core processor, it has a long battery life.
Battery Notes
- Do not allow the battery to sit idle for too long, either in product equipment or in storage. If the battery is 6 months old, check the state of charge or dispose of the battery properly.
- Lithium-ion batteries typically have a life of two to three years and 300 to 500 cycle charges. A full charge cycle is a complete charge, a complete discharge, and then a complete charge.
- Rechargeable lithium-ion batteries have a limited life span and gradually lose their ability to hold a charge. This amount of loss (aging) is unchangeable. When the battery loses capacity, the service life is reduced (run time).
- The lithium-ion battery continues to slowly (automatically) discharge when it is not being used or when it is idle. Check the battery charge status frequently, or refer to the instruction manual for information on how to charge the battery.
- Observe and record a battery that is unused and fully charged. Based on new battery run time, compared to a battery with longer run time. Battery runtime will vary depending on product configuration and application.
- Check the battery charge status regularly.
- The battery charge time increases significantly as the battery runtime drops below approximately 80% of the original runtime.
- If the battery is left idle or unused for a long period of time, you need to check if it still has a charge and if the battery has any charge left, do not try to charge it or use it. Should have gotten a new battery. Remove the battery and place it separately.
- Battery storage temperature from 5°C to 20°C (41°F to 68°F)
- Note: Replacing batteries with the wrong type poses a risk of explosion, so be sure to dispose of used batteries according to the instructions.
Adapter Notes
- Products are shipped without adapters, if consumers use power adapters to supply power, they should purchase power adapters that meet the requirements of the corresponding safety standards or power adapters that have obtained CCC certification
Installation Guide
Appearance
Install Micro SD, SIM card
The locations of the card slots are as follows.
Battery charging
Charge the battery via the USB port using the original adapter, do not use other brand adapters to charge the device.
Button and function area display
The LT60H device is divided into 5 side button
Telephone function
Make a phone call
Click .
Tap the number keys to enter the telephone number.
Tap to dial.
Tap to end the call.
Contacts
Click ‘Contacts’ to open the contacts list.
Click to add the new contact.
SMS and MMS
Click to open the message list.
Click to type text message to input the content.
Click to add photos, videos.
Multimedia
Camera
You can turn on your camera and capture every moving moment at any time.
Photographic interface.
- Click to switch the photo mode.
- Click to switch the flash mode.
- Click to check photos or videos.
- Click to take a photo.
- Click Video to switch to video, click start recording.
Gallery
Users can view photos and videos through the gallery.
View pictures and video
- In the pull-up menu, click .
- Select the folder of images to view.
- Click on the image or video to view it full screen.
Show slide
- In the pull-up menu, click .
- Select the folder of images to view.
- Click and select to broadcast the slideshow.
Edit photos
- In the pull-up menu, click .
- Select the folder of pictures you want to view.
- Select a picture, touch the picture, click , you can start editing the picture.
Delete image
- In the pull-up menu, click .
- Select the folder of pictures you want to view.
- Select a picture, click , and then click Delete to delete the picture.
Share pictures and videos
You can share pictures and videos via email, Bluetooth, and many other ways.
- In the pull-up menu, click .
- Select the folder of pictures you want to view.
- Select a picture, click , and you can finish sharing the picture and video.
Music
The controller has a built-in music player, so you can play your favorite songs whenever you want.
Add music
Before playing the music, users need to copy the music files to the
controller, as following shows:
- Copy via USB connection cable to a computer.
- Download via the Internet.
- Copy the music files to the controller via USB cable or bluetooth connection.
Play music
- In the pull-up menu, click .
- Click the Song button to select the song you want to play.
- Go to the player interface and enjoy the music.
Trouble shooting
Abnormal power on
If you encounter an abnormal boot situation, as shown below, the phenomenon is caused by triggering the Power button + number 1 + number 6 at the same time to enter Recovery mode, you can use the ↓ key on the keyboard to move to the Normal Boot option, press OK key to confirm the boot. After reboot you need to check whether the side buttons are back to normal. If the side buttons do not rebound properly, please contact your local supplier.
If you accidentally enter Recovery Mode and select Fastboot Mode to reboot, as shown below. Just press and hold the power button for 11 seconds to force a reboot.
If you accidentally enter Recovery Mode, you select Recovery Mode to reboot, as shown below. Just press and hold the power button for 11 seconds to force a reboot.
Hang up
If you get stuck and jammed during system use and cannot perform touch screen operations, you can restart by long pressing the power button for 11 seconds.
Product Specifications
Equipment parameters
Size| 224mm80mm15.4mm
Weight| 340g
Display screen| 5.45″, HD+ 1440 x 720 pixel resolution
Keypads| Power,Numeric Keypad
Battery| Rechargeable Li-Polymer Battery 6240mAh
Pistol bat. (rechargeable li-ion polymer, 3.7V, 5200 mAh)
Storage Expansion| Micro-SD/TF (supports up to 128GB)
Expansion Card Slot| 1 Nano SIM card slot
Sound frequency| Microphone, speaker (1W), voice call support
As the circumstances allow| 13 megapixels, flash support, continuous snapshot
mode
Sensors| Gravity Sensor, Gyroscope, Electronic Compass, Light and Proximity
Sensor
Screen brightness| 500 nits maximum brightness (typical)
Touchscreen| Asahi Glass, multi-touch support, glove or wet hand operation
Performance Parameters
CPU| MTK6762 2.0GHz Octa-core
★ Operating System| AndroidTM 10
Running memory| 3GB
Data transmission| USB2.0 Type-C,OTG
Storage| 32GB
Storage Expansion| Support 128GB Micro-SD
Working environment
Operating temperature| -55℃~+85℃
Storage temperature| -55℃~+85℃
Ambient humidity| 5% RH – 95% RH (no condensation)
Drop height| Drop height 1.5 m, 6 sides, 4 corners, 2 times each side, two
cycles.
Platen| Rolling 1000 consecutive times 0.5m, stable operation even after 6
face contact surface rolls, meeting IEC rolling specifications.
Waterproof and dustproof| IP67 rating according to IEC 60529 (1m deep long
stationary bucket, handpiece immersed in water, distance from bottom of sample
to water surface at least 1m, immersion time at least 30min.)
Static Protection| CLASS 4 rating Air type: ±15KV
Contact type: ±8KV
Wireless connection
WWAN| 2G: GSM850/GSM900/DCS1800/PCS1900
3G: CDMA EVDO: BC0
WCDMA: B1/B2/B4/B5/B8
TD-SCDMA: A/F(B34/B39)
4G: B1/B2/B3/B4/B5/B7/B8/B12/B17/B20/B26/ B28AB/B38/ B39/B40/B41
WLAN| IEEE802.11 a/b/g/n/ac, (2.4G/5G)
Bluetooth| Bluetooth v2.1+EDR,3.0+HS,v4.1+HS
NFC| Backing
Equipment Remarks
Restrictions.
AT| BE| BG| HR| CY| CZ| DK
EE| FI| FR| DE| GR| HU| IE
IT| LV| LT| LU| MT| NL| PL
PT| RO| SK| SI| ES| SE| UK
The European version of the device is limited to indoor use in European communities using frequencies from 5150MHz-5350MHz to reduce the potential for interference.
Declaration
Equipment declaration:
Ltd. hereby affirms that the radio equipment model LT60H complies with the
Directive 2014/53/EU, and the full text of the EU conformity declaration is
available on the official website: https://www.chcnav.com/.
- FCC 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
2)FCC 15.21
Warning: Changes or modifications to this unit not expressly approved by the
part responsible for compliance could void the user’s authority to operate the
equipment.
- FCC 15.105
For a Class B digital device or peripheral, the instructions furnished the user shall include the following or similar statement, placed in a prominent location in the text of the manual:
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Specific Absorption Rate (SAR) information:
This Smart Phone meets the government’s requirements for exposure to radio
waves. The guide lines are based on standards that were developed by
independent scientific organizations through periodic and thorough evaluation
of scientific studies. The standards include a substantial safety margin
designed to assure the safety of all persons regardless of age or health.
FCC RF Exposure Information and Statement:
The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue.
Device types: Smart handheld printer (FCC ID: SY4-B01016) has also been tested
against this SAR limit. During product certification, the maximum SAR value
reported according to this standard is less than 1.6W/kg when correctly worn
on the vehicle body. This device was tested for typical body-worn operations
with the back of the Smart Phone kept 0cm from the body. To maintain
compliance with FCC RF exposure requirements, use accessories that maintain a
0cm separation distance between the user’s body and the back of the Tablet PC.
The use of belt clips, holsters and similar accessories should not contain
metallic components in its assembly. The use of accessories that do not
satisfy these requirements may not comply with FCC RF exposure requirements,
and should be avoided. Very high volume, prolonged listening to a mobile phone
can damage your hearing.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>