Gocheer GH-Monster Air Purifier User Manual

Gocheer GH-Monster Air Purifier

Introduction

Product Description

• A: Control Panel
• B: Outlet Filter
• C: Air Quality Indicator
• D: Inlet Filter
• E: Power line
• F: Sensor Cover
• G: Casters

Control Buttons

1. Show PM2.5
2. Smart Mode
3. Wind Speed Adjustment
4. Sleep Mode
5. Lighting Function
6. Switch
7. Timing Button
8. WIFI Function
9. Filter Reset
10. Child Lock

Safety Precautions

Before using the product, please read our manual carefully and keep it properly. You need to read instructions carefully and follow the suggestions below:

• For your safety, our product complies with applicable standards and regulations (low voltage, electromagnetic compatibility, environmental protection.
• Our product is not suitable for people with physical, sensory or mental disabilities (including children), or those who lack use experience or related knowledge, unless there is a person who is responsible for their safety to supervise, or give them relevant instructions for machine use in advance;
• I Children should be supervised to ensure they do not play with this product;
• I This product is prohibited to be used by children under eight years of age, people lacking relevant experience and knowledge, or persons with physical, sensory or mental disabilities.Otherwise,they must be trained or instructed to understand how to use this product safely and know this product is involved danger;
• I If the power line is damaged, do not use this product.For avoid danger, Please contact the manufacturer or Technical Support for new power line instead using other brand power lines to replace;
• Children mustn’t clean and maintain the product without supervision;
• When maintaining the product, you should refer to the “About Maintenance” section in the manual; I Keep the power line out of reach children under eight years of age;
• This product is specially designed for indoor use and shouldn’t be used in industrial .
• If the product is damaged due to improper operation, the warranty card is invalid;
• Don’t use the product in dusty, humid or fire hazard places;
• Please ensure the electrical plug and power line are good before use;
• Don’t insert unknown objects into the device (such as needles);
• Do not pull the power line or equipment, or even pull the plug from the socket;
• Expand the length of the power line to a suitable length before use;

Warning

• Don’t cover the air inlet or air outlet.
• Don’t touch the devices with wet hands.
• Don’t allow any liquid to enter this product.
• Don’t use this product in a humid place.
• Don’t make this product close to the heat source.
• Don’t place anything or insert any unknown objects on this product.
•  Please don’t put this product close to flammable items (such as curtains, aerosols, organic solvents, etc.)
• Use the product on a stable surface, please don’t use the product by tipping or tilting it;
•  When the product isn’t used for a long time: please press the button (6) to turn off the device and unplug the power plug. I Please turn off the equipment and unplug before moving.
•  Please unplug when assembling or cleaning equipment.

Working Theory
The filtering system of this machine filters large particles of dust, hair, PM2.5, formaldehyde, allergens, etc. Thereby removing odors, purifying pollutants in the air to refresh the air, and protecting your and your family’s health.

Before Use

Choose a room which needs purify the air, then place the purifier on the stable floor or table in the room. For allow air to circulate freely, please avoid placing the purifier behind curtains, under windows,furniture,or next to the shelf and close to any obstacles.Ensure at least on each side of the purifier Keep 50cm of free space. Please stay away from the humidifier and aromatherapy device,when the air purifier is turned on. Otherwise the display of PM2.5 will rise sharply (because the sensor is judged throught scattering oflight) Before use the first time, please confirm the filter bag inside the machine has been removed. Please also confirm:

• Your home voltage matches the voltage of the equipment logo;
•  Please Connect the machine and power line before use;
• The air inlet and outlet are completely unobstructed;
• The filter and bottom cover are installed correctly (see below);
• If the bottom cover isn’t installed correctly, the equipment will not work properly.
• Instructions for removing filter packaging for the first time and replacing the filter after the life of the filter expires.

1. Put your fingers on the panel clasps on both sides of the product, pull outwards and remove the cover.
2. Remove the HEPA composite filter inside the product.
3. Remove all plastic packaging on the HEPA composite filter.
4. The side with activated carbon faces the inside of the product, and then put the filter back in the direction of the arrow.
5. When install both sides of the panel back, filter installation is completed.

Instructions For Use

• Turn the power on and touch the on/off switch to turn the purifier on or off
• After power on, the digital tube frame of the operation panel will flash for 5S, and the air quality test is completed.
• The table on the right is the corresponding relationship between the display number and the indicator color.

Turn on the network distribution mode, so that the machine can be controlled by APP. The indicator light has three states. The first state: Long press the wifi button for 3s to enter, the indicator flashes quickly and enters the quick connection mode The Second state: In quick connection mode, long press 3S again to enter compatibility mode The third state: The indicator light is always on, the network configuration is completed, and the machine can be controlled by APP.

0-15| Green| Better
13-35| Buie| General
36-55| Yellow| Light pollution
56-150| Red| Moderately polluted
150 above| Purple| Heavy pollution

• You can select the purification speed in turn by touching the air speed control button. There are four levels of wind speed, the higher the level, the higher the purification wind speed.
• The smart indicator lights up, the device will automatically adjust the wind speed according to the air quality data detected by the sensor, which is suitable for most application scenarios.
• The purifier is running at the Level 1 speed, except for the sleep indicator and the wind speed button half-bright display, the rest of the lights are all off
• Make the equipment run within the set time(time range: 1-8h), the machine will stop running if it exceeds the set range. (9 Timer mode on , press and hold the buttonfor 3 seconds to cancel the timer.
• Long press the 3S child lock function to turn on/off
  • The child lock function is on and the indicator light is always on.
  • When the child lock function is on, operate other keys, the child lock icon flashes.
• Turn on the light function, the light icon is always on, and all lights are displayed normally.  Turn off the light, the light icon is half bright, operation is completed, all lights will be off after 3S.
• After the filter is replaced, press this button for 5S to reset the filter life. The indicator will appear in three states. The first state: When the filter indicator keeps red, it means the filter needs to be replaced The second state: When the filter indicator light flashes for a long time, it indicates that the filter life is within 48 hours. The third state: When the filter indicator flashes once, it means the filter reset button is touched. If you need to replace the filter midway, please follow the steps below: CD Press and hold the reset button for 5S to clear the remaining filter life, at the same time filter indicator light up red.
  In 15S, press and hold the filter reset button again for 5S to reset the filter, At this time, the indicator light flashes quickly and the buzzer sounds 3 times to complete the filter reset.
  Note! If there is no long press of the filter reset button within 15 seconds, the filter life state before the first long press will be restored.

Product Added to APP

Download App
You can download the App by searching “Tuya Smart”in mobile app stores or scanning the following QR code.
Register/Log in
If you already have a Tuya account, log in directly; otherwise, click Register and follow the prompts to register a Tuya account.
Add Devices

1. lick “Add Devices”or “+”in the top right comer to enter add device page. Choose to add manually. 
2. Choose small appliances, then choose air purifiers.
3. Select 2.4GHZ Wi-Fi network and enter the password.
4. Press and hold the Wi-Fi button of the air purifier for 3S to enter the fast flashing state (0.5s/time) .
5.  Wait for pairing to complete.
6. Registration is complete.
7. Enter the device operation interface.

Product Configuration and Parameters

About Maintenance

Before any maintenance operations, be sure to tum off the power by pressing the button (6) and cut off the device power . You can use a slightly damp cloth to clean the product body.
Important Note: Do not use any objects with friction properties to avoid damaging device surface.

3000 hours

This data is based on calculation oflow-grade purification wind speed;  The recommended frequency of filter replacement varies according to the duration of use and the working environment.

• If the filter indicator keeps red, Activated carbon, Antibacterial cloth and HEPA composite filter screen needs to be replaced.

Note: Activated carbon, Antibacterial cloth and HEPA composite filter screen can’t be washed or used repeatedly. Don’t wash it with water. Replace the filters in sequence, please refer to “Before Use”-“Removing Filter Packages for the First Use and Instructions for Replacing Filters After the Life Expires”

Warm tips

• If you are allergic or have asthma, please avoid touching the used filter;
•  Please wear gloves when replacing the filter, or wash your hands after replacement;
• Put the used filter into a sealed bag and throw it away to avoid spread of contaminants.

Cleaning and Maintenance of Primary Filter

1. Put your fingers on the panel clasps on both sides of the product, pull outwards and remove the cover.
2. Remove the primary filter on the cover.
3. Rinse the primary filter with clean water.
4. Place the primary filter in the sun to dry.
5. Put the primary filter back on the cover.
6. G, When install both sides of the panel back, filter installation is completed.

Storage Conditions

• Store the purifier in a dry, cool place if it will not be used for a long time.
•  Please keep store this product out of the reach of infants or children.
• Do not place objects on this product.
• Do not store in direct sunlight and high temperature places.
• If the product is not used for a long period of time (more than 30 days), it is recommended to remove the filter from the body and store it in a plastic bag.

Common faults

• Do not disassemble the machine privately; improper repair may cause danger to users.
•  Regarding the noise, the fan speed is different for different air volumes is running. When the fan is running at high speed, it will produce a certain amount of noise, which is a normal phenomenon.
• The purification effect is not good, whether the room area is too large, please use it within the room area recommended by this product. For other failures, please contact technical support : surpport@gocheer.us

Common faults

Before contacting the after-sales service center, please check the following troubleshooting:

can’t act

| Is the power supply plugged in?| Plu g in the power sup ply at the correct voltage
Are all in dicators off?| Press switch button to sele ct the desir ed function
ls there a power outage?| The device is available when power is restored

Airflow is much weaker than before

| Does the filter need to be replaced?| Check whether the filter has reached the replacement cycle ; replace the filter if necessary
ls the entrance blocked?| Remo ve the obstruction
Please confirm whether the current”Operation Mode” is “Automatic Mode” or “Sleep Mode” ?| change the operation mode with the “Air Speed Button”
Odor at the air outlet| Does the filter need to be replaced?| Check whether the filter has reached the replacement cycle; replace the filter if necessary
Set to automatic mode, but the wind speed can’t be

changed automatically

|

Is the sensor part blocked by walls or obstacles?

| If it is blocked by a wall or an obstacle, please remove the obstacle, otherwise please clean the “sensor” part on the back of the host
The filter reset button keeps turning red| Has the filter replacement mark reset been implemented ?|

Please reset the filter displ ay

Wind speed can’t be chang ed automatically|

Is it manual mode?

|

Choose the right operating mode

PM2.5 shows rise sharply in a short time| ls there humidifier and aromatherapy device in the room?| If so,keep air purifiers away from them
Can’t connect to APP| Whether to use 2.4GHz network connection?| Sele ct 2.4GHz network to connect

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>