PRIME BRANDS GROUP WCP2/WCP3 Wireless Charging Pad Instructions
- June 5, 2024
- Prime Brands Group
Table of Contents
PRIME BRANDS GROUP WCP2/WCP3 Wireless Charging Pad
CONTENTS:
- Wireless charging base
- USB Cable
FEATURES
- 10W charging power for Smartphones and other wireless charging enabled charging devices.
- Universal compatibility works with wireless enabled devices
- Integrated safety features – Over voltage, Under voltage, Over Current protection.
- Sleek, compact design with non‐ slip rubber base.
SAFETY INFORMATION
- This product is only suitable for Wireless enabled charging devices
- Do NOT short circuit or burn
- This is NOT a toy
- Keep dry at all times. Do NOT immerse in liquids
- For indoor use only
- Do NOT attempt to disassemble. Does not contain serviceable parts
- Avoid dropping, shaking or any hard impacts on the product
- Do NOT attempt to plug foreign objects into the product
SETUP:
- This product is only suitable for Wireless enabled charging devices.
- Take the supplied charging cable and connect it to the Charging Mat then connect the cable to a USB A power source, this can be the charger supplied with your smartphone for example and then switch on.
- Refer to your wireless enabled device and enable wireless charging – this may be in the battery settings on your device.
- Simply place your device in the centre of the Charging Mat to commence charging.
- If charging does not commence immediately then reposition your device on the Charging Mat until your device begins to charge.
- When your device is fully charged switch off the power source or remove your device from the Charging Mat.
TECHNICAL DETAILS
- Input: 5V@2A / [email protected]
- Output: 5V@1A/ [email protected]
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between
the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co‐located or operating
in conjunction with any other antenna or transmitter. During the operation of
device a distance of 15 cm surrounding the device and 20 cm above the top
surface of the device must be respected.
FCC ID : 2AY4Z‐WCP2 ‐WCP3