singing machine SMM548C Device Instruction Manual
- June 5, 2024
- Singing Machine
Table of Contents
singing machine SMM548C Device
Included What’s in the box
- Manual
- USB Charging Cable
Warnings
DRIPPING WARNING: This product shall not be exposed to dripping or splashing, and no objects filled with liquids, such as vases, shall be placed on the product.
Warnings
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
To parents recommend that the adaptor be periodically examined for conditions
that may result in the risk of fire, electric shock, or injury to persons and
that, in the event of such conditions, the adaptor should not be used until
properly repaired.
FCC WARNING
This equipment may generate or use radiofrequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made. This device complies with part 15 of the FCC Rules.
Operation
Subject to the following two conditions:
- This device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Specifications
-
AUDIO SECTION
Output Power ………………………………………………………………………. 3 Watts (RMS)
Output Impedance …………………………………………………………………………… 3 Ohms
BLUETOOTH
Bluetooth Version …………………………………………………………………………………. V5.0
Working Distance ……………………. Up to 10 meters measured in open space
HEADPHONE SECTION ………………………….. 3.5 mm Stereo headphone jack -
POWER SECTION
Battery ……………………………………………. Lithium-ion battery 3.7 V 1,200 mAh
Input Power …………………………………………………………… Micro USB 5VDC 1A
DIMENSIONS (each mic) ……………………………………………………………………………
3.4 x 2.2 x 10 (inches) / 8.6 X 5.5 X 25.3 (cm)
WEIGHT (each mic) …………………………………………….. 0.25 (kgs) / 0.55 (lbs)
Statement: The battery is not replaceable
- Troubleshooting Guide
- Should this unit exhibit a problem, check the following before seeking service:
- No Power
- The power is not on; press and hold the / button to turn the power on.
- Confirm that the unit is charged.
- No Sound – General
- Volume is set to a minimum; raise the volume of your Bluetooth music device by its volume control. No sound from the microphone
- Microphone volume is set to a minimum; raise microphone volume by pressing VOL + button up. Bluetooth reception failure
- Put the external Bluetooth device close to the unit.
- Pair the unit with the Bluetooth Device as the procedures stated in this manual.
Important Safety Information
- Read these Instructions.
- Keep these Instructions.
- Heed all Warnings.
- Follow all instructions.
- Do not use this apparatus near water.
- Clean only with a dry cloth.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Only use attachments/accessories specified by the manufacturer.
- Unplug this apparatus during lightning storms or when unused for long periods of time.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
- WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. Do not place objects filled with water, such as a vase, on the apparatus.
- CAUTION: To reduce the risk of fire or explosion, do not expose batteries to excessive heat such as sunshine, fire, or other heat sources.
Energy Saving Mode (Auto Power System-APS)
The unit will automatically switch off after 30 minutes in the following situations:
- There is no singing into the microphone;
- The Bluetooth music has been stopped.
The unit can be switched on again by pressing and holding / the button. APS is
for energy-saving purposes. Specifications are subject to change without
notice. Please retain the
instructions for further reference, as they contain important information.
Before you get started
EXIT “TRY ME” MODE
Press and hold the / button 2 seconds or charge the unit to exit the “TRY ME”
mode.
CHARGING THE UNIT
- Insert the included USB charging cable into the unit’s micro USB port
- Plug the other end of the cable into a computer’s USB port or other USB charging device (not included). We recommend charging the unit for 4 hours to ensure it is fully charged.
- The speaker will light in red and slowly flash while the unit is charging. The light will turn off once the unit is fully charged.
- NOTE: Please charge the unit when you see the light on the speaker flashing red
CONNECTING HEADPHONES
For private listening or to monitor singing, use headphones (not included). Insert headphones into the Headphones jack
- Press and hold the / button to turn the unit on (either one of the microphones); the power indicator will light.
- Press the / button repeatedly to select Light mode as follows:
- Light Mode 1-5: The speaker will light up with changing light colors. When there is music playback or singing, the lighting will flash with the audio signal.
- Light Mode 6: The speaker will light up with color-changing lights continuously.
- Light Mode 7: The light will be turned off. You can adjust the microphone volume by pressing the VOL + or – button
SING-ALONG WITH BUILT-IN VOICE CHANGERS
There are 6 built-in voice changers in this unit. When pressing the FX or
button the speaker light will change. The voice will change when the singer
starts to sing through the microphone. Purple light – ECHO Pink light – FEMALE
Orange light – MALE Limelight – CHIPMUNK Cyan light – ROBOT Blue light –
RADIO. Select white (NONE) to sing without any voice effect. To sing without
the lead singer on the recording, press the VOCALS button. To resume the lead
singer, press the VOCALS button again.
Note : Lead vocal removal may work better on some songs than others.
TO START SINGING WITH ONE MIC ONLY
CONNECT A BLUETOOTH DEVICE
Switch on the Bluetooth function of your Bluetooth-compatible device within
three feet of the unit. You will see “Singing Machine DUETS” appear on your
device’s search list.
Select “Singing Machine DUETS” to start pairing. A chime will confirm the
pairing was successful.
Notes
- When both microphones have been switched on, you can only pair one microphone.
- Press and hold the button to disconnect the Bluetooth device.
TO ADD A SECOND MICROPHONE FOR DUET PERFORMANCES
Switch on the other microphone. Press and hold the DUETS button on either one
of the microphones within three feet of the other microphone. The Bluetooth
indicator will flash red. Wait for the completion of the
TO LINK BOTH MICROPHONES TOGETHER FASTER
Turn both microphones on. The speaker will light up by indicating light colors. Press and hold the DUETS button on either one of the microphones within three feet of each other. The microphone will make a sound to indicate both microphones are paired together. Switch on the Bluetooth function of your Bluetooth-compatible device within three feet of the microphones. You will see one “Singing Machine DUETS” appear on your device’s search list. Select “Singing Machine DUETS” to start pairing. Wait for the completion of the pairing. Both microphones will make a sound indicating that they have paired with Bluetooth devices.
- Note: Press and hold the DUETS button to switch off the DUETS mode. Remember to press and hold the DUETS button again when you want to turn on Duets mode.
- Notes
- If your Bluetooth device prompts you for a passcode during the pairing process, please enter “0000” to connect. If pairing fails, repeat steps. If you have paired before, a list of previously searched results will be displayed. Select “Singing Machine DUETS” again. On some Bluetooth devices (i.e., computers), once pairing is completed, you must select your Bluetooth device as “Use as Audio Device” or similar.
- Ensure any other Bluetooth devices are turned off to avoid accidental pairing.
- Please always refer to the user manual of your Bluetooth device for detailed instructions.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>