TRISTAR KA-5074 Digital Ceramic Heater Instruction Manual
- June 3, 2024
- Tristar
Table of Contents
TRISTAR KA-5074 Digital Ceramic Heater
Instruction manual
SAFETY
-
By ignoring the safety instructions the manufacturer cannot be held responsible for the damage.
-
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
-
Never move the appliance by pulling the cord and make sure the cord cannot become entangled.
The appliance must be placed on a stable, level surface. -
The user must not leave the device unattended while it is connected to the supply.
-
This appliance is only to be used for household purposes and only for the purpose it is made for.
-
This appliance shall not be used by children aged less than 8 years. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Keep the appliance and its cord out of reach of children aged less than 8 years. Cleaning and user maintenance shall not be made by children unless older than 8 and supervised.
-
To protect yourself against an electric shock, do not immerse the cord, plug or appliance in the water or any other liquid.
WARNING: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present. -
Children of less than 3 years should be kept away unless continuously supervised.
-
Do not use the appliance with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly. Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
Please do not install the appliance close to curtains and other combustible materials. This could cause a fire. -
The heater must not be located immediately below a socket-outlet.
-
The heater needs to be installed so that the switches and other controls cannot be touched by a person in the bath or shower.
-
WARNING: In order to avoid overheating, do not cover the heater.
PARTS DESCRIPTION
- Vent
- Main power switch
- Display
- Control panel
- On/Off/ icon
- Mode icon
- Timer icon
- [ECO] icon
- Oscillation icon
- Minus icon
- Plus icon
- Anti-frost indicator
- Fan mode indicator
- Low heating indicator
- High heating indicator
- Timer indicator
- Power/ Standby indicator
- Eco mode indicator
- Time/ temperature indicator
BEFORE THE FIRST USE
• Place the device on a flat stable surface and ensure a minimum of 10 cm.
free space around the device. This device is not suitable for installation in
a cabinet or for outside use.
When the device is turned on for the first time, a slight odour will occur.
This is normal, ensure adequate ventilation. This odour is only temporary and
will disappear soon.
USE
- Place the appliance on a stable and flat surface.
- Press the On/Off switch at the back of the appliance to turn the appliance on in standby mode. The appliance will beep once and the standby indicator will blink continuously.
- Press the On/Off icon on the display to turn the appliance on. The anti-frost feature will be activated by default, the anti-frost icon will show in the display and the current room temperature will be displayed.
During this time the integrated thermostat will monitor the current room
temperature and automatically activate heating and fan modes to maintain the
temperature at 7°C. When the room temperature is lower than 7°C it will
operate in heating and fan mode until the temperature reaches to 7°C, when the
temperature reaches 7°C the heater and fan will automatically stop.
NOTE: The indicated temperature on the heater may deviate in standby mode
but stabilizes once the appliance has been activated.
- Press the Mode icon to select the desired mode – Fan – High Heating-Low Heating.
- The appliance will start operating in the selected mode shown in the display.
Fan mode
- In Fan mode the appliance will blow cool air.
Low heating mode
- In Low heating mode the appliance will blow warm air at a low speed. High heating mode
- In High heating mode the appliance will blow warm air at high speed.
Adjusting the temperature
- When using the heating modes, you can adjust the temperature between 10°C and 35°C using the Plus and Minus icons. The temperature will blink in the display then revert to the current room temperature.
- You can adjust the temperature in fan mode, if the temperature set is higher than the current room temperature it will operate in heating mode.
ECO function
- To activate the ECO function, press the ECO icon on the display. The ECO symbol will show in the display and the appliance will start operating in ECO mode.
- The ECO function compares the target temperature with the current room temperature and automatically selects the most appropriate heating level to guarantee an optimum comfort level, while reducing the energy consumption. While the ECO function is on, the appliance may switch alternately between the Low and High heating levels.
Timer function
- Activate the desired operating mode.
- Press the Timer icon. The timer symbol will show in the display and the time.
- Use the Plus and Minus icons to set the desired time. After 5 seconds, the display will revert to showing the current room temperature.
- The Timer can be set between 1-24 hours.
Oscillation function
- To activate the oscillation function, while the appliance is in use, press the Oscillation icon. The appliance will start oscillating.
- To deactivate the oscillation function, press the Oscillation icon again. To turn the appliance off.
- When the appliance is not in use, turn the standby switch off and unplug the appliance.
CLEANING AND MAINTENANCE
- Unplug the appliance and allow it to cool down. Use a soft, slightly damp cloth to wipe appliance surfaces. Do not allow water or any other liquid to get into the unit.
- Clean the air suction opening from time to time with a fine brush.
ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its durability, but must be offered at a central point for the recycling of electric and electronic domestic appliances. This symbol on the appliance, instruction manual and packaging puts your attention to this important issue. The materials used in this appliance can be recycled. By recycling of used domestic appliances you contribute an important push to the protection of our environment. Ask your local authorities for information regarding the point of recollection.
Support
You can find all available information and spare parts at service.tristar.eu!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>