FIAMMA 02094-24A Carry-Bike VW Caddy Instruction Manual

June 5, 2024
FIAMMA

FIAMMA 02094-24A Carry-Bike VW Caddy

FIAMMA 02094-24A Carry-Bike VW Caddy

CARRY-BIKE

FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-2

Package contents

Check that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. We recommend that the installation is carried out by qualified personnel and in compliance with current local regulations.

FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-3 FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-4 Do not completely tighten the screwsFIAMMA 02094-24A Carry-Bike VW Caddy-
FIG-7 FIAMMA 02094-24A Carry-Bike VW Caddy-
FIG-8 Mount the bar with the brackets in this position.FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-9 FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-10 FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-11 FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-12 Tightening max 1,5 NmFIAMMA 02094-24A Carry-Bike VW Caddy-
FIG-14 Rotate the brackets in this positionFIAMMA 02094-24A Carry-Bike VW Caddy-FIG-16

Tighten the screws firmly

FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-17 WARNING!
Do not fully tighten the fork to the tube, leave 2mm space.FIAMMA 02094-24A
Carry-Bike VW Caddy-FIG-18 FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-19 FIAMMA 02094-24A Carry-Bike VW Caddy-FIG-20 In case of problems please contact your local dealer indicating the data on the nameplate. Consult our website for the spare parts drawing.FIAMMA 02094-24A
Carry-Bike VW Caddy-FIG-22 Read the following instructions and warnings carefully; failure to observe these installation and usage instructions, as well as the laws for driving in the relevant country, may cause severe harm or damage for which the manufacturer declines all responsibility. Before installation, ensure compatibility with the vehicle on which the product must be installed.

Checking that the wall/rear door is sufficiently solid and suitable for guaranteeing the resistance of the anchoring points is always mandatory. If not, strength and compliance with the maximum load indicated in the instructions are not guaranteed and it will be necessary to reinforce these points.

After having positioned the Carry-Bike on the rear axle of the vehicle, the normal weight distribution on both axles would be modifi ed. This variation must not exceed the maximum permissible axle load.

Never exceed the maximum permitted length and the total weight of the full- load vehicle.
Make sure that loading occurs following a correct weight distribution; it must be uniformly distributed (the heaviest bike must be placed near the wall of the vehicle) to ensure better stability.

Always give warnings about the presence of the Carry-Bike on your vehicle, using a clear signal for leaning loads and, in case of limited rear visibility, use the additional rear-view mirrors.

Take into account the presence of the Carry-Bike, pay attention during driving and especially during reversing maneuvers, particularly if you have a parking assist system.

Always comply with speed limits and the Highway Code.
The speed should always be suitable to traffic conditions and towed load.
In case of use of the bike carrier with tow make sure that the tow hook is always accessible and the corner mobility of the tow is guaranteed (volume measuring din 74058).

Check periodically the bicycle rack to make sure it is firmly attached, especially during the first kilometers of after long trips to avoid damage of the Carry-Bike/vehicle. Make sure the belts are not loose and that the holding brackets have not shifted. Replace worn components immediately.

While assembling, pay attention not to close the rear door if the screws of the lower bar of the Carry-Bike are not tightened, the body of the vehicle could be damaged.

During Carry-Bike installation, verify that there is enough distance between handlebars and/or pedals and the vehicle’s rear windows in order to avoid any damage of the window van; do not leave accessories attached (bay seats, baskets, etc) because vibrations could disengage bikes.
In some cases, the rear windscreen wiper may not work due to the presence of bicycles. Be aware of the brush radius before operating the windscreen wiper.

On this type of Carry-Bike, bike covers are not allowed (Bike Cover).
Depending on the type of bicycles transported, check the correct visibility of the rear lights. If the visibility is missing, provide a light repeater bar.
You can open the tailgate with the Carry-Bike mounted without bikes.
It is recommended to rotate the handlebars of bicycles to avoid damage to the vehicle wall, for which Fiamma declines all responsibility.

Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer is entitled to the warranty in accordance with local laws and regulations of the country in which the product was purchased.

fiamma.com

All rights reserved. Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials, specifications and models or to cease production of any model.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals