DELTACO ARM-0352 Counterbalance Monitor Arm User Manual
- October 30, 2023
- DELTACO
Table of Contents
DELTACO ARM-0352 Counterbalance Monitor Arm
Product Information: Counterbalance Monitor Arm
The Office ARM-0352 is a Nordic brand counterbalance monitor arm designed to securely hold computer monitors in place. The arm can be installed on wooden stud walls, solid concrete walls, or brick walls. The product comes with mounting screws and small parts that could be a choking hazard if swallowed. The product is intended for indoor use only and should not be used outdoors as it could lead to product failure and personal injury. The maximum weight capacity should not be exceeded as it may result in serious injury or property damage.
Usage Instructions
- Read the entire instruction manual before starting installation and assembly.
- Caution: Usage together with products heavier than the rated weight may result in instability which can cause possible injury.
- Ensure proper installation to prevent serious injury. Safety gear and proper tools must be used during installation.
- Make sure that the supporting surface can safely support the combined weight of the equipment and all attached hardware and components.
- Check that all parts are received according to the component checklist prior to installation. If any parts are missing or faulty, contact Deltaco or the retailer where you purchased the product.
- Caution: Do not exceed the marked max weight. Serious injury or property damage may occur!
- Use the mounting screws provided and do not over tighten them.
- Check that the wall mount is secure and safe to use at regular intervals (at least every three months).
- Keep small parts away from children as they could be a choking hazard if swallowed.
Dimension
Tools
Assembly Procedure
WARNING STORED ENERGY
Hold the monitor arm firmly with 1 hand on each opposite side. Ask another
person to cut off the cable tie. Slowly release the pressure until it is fully
extended
old the monitor arm horizontally to avoid damage to monitors or monitor arm. Ask for help from a 2nd person if needed.
If the monitor arm is falling, turn it counterclockwise until it stays in place
If the monitor arm is rising too much, turn it clockwise until it stays in place.
If the monitor does not stop at desired position, tighten the screws.
Safety Instruction
- Read the entire instruction manual before you start installation and assembly.
- If you have any questions regarding any of the instructions or warnings, please contact your retailer for assistance.
- Caution: Usage together with products heavier than the rated weight may result in instability which can cause possible injury instructions. Improper installation may result in serious injury.
- Safety gear and proper tools must be used. This product
- Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
- This product is designed to be installed on wooden stud walls, solid concrete walls or brick walls.
- Use the mounting screws provided and do not over tighten the mounting screws.
- This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
- Important: Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact Deltaco or the retailer where you purchased the product.
- Caution: Do not exceed the marked max weight. Serious injury or property damage may occur!
- Check that the wall mount is secure and safe to use, at regular intervals (at least every three months).
DistIT Services AB, Glasfibergatan 8, 125 45 Älvsjö, Sweden
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>