Rowenta SO2040F0 Sprinto Silence Bathroom Fan Heater Instruction Manual
- June 5, 2024
- Rowenta
Table of Contents
Rowenta SO2040F0 Sprinto Silence Bathroom Fan Heater
PRODUCT OVERVIEW
- A. Function-selection switch
- B. Temperature-control switch: Thermostat
- C. On/Off indicator
- D. Air intake screen
- E. Air outlet screen
- F. Transport handle
- G. Power cord holder
Please read it carefully and keep in a safe place.
WARNINGS
It is essential that you read these instructions carefully and comply with the following recommendations.
- For your safety, this appliance complies with the applicable standards and regulations (Low Voltage Directive, Electromagnetic Compatibility, Environmental…).
- Before using, always check the condition of the appliance, the power socket and the power lead.
- Do not pull on the power cable or the appliance, even to unplug it from the wall socket.
- Fully unwind the lead each time before use.
- Never insert objects into the appliance (e.g. needles…).
- This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and know-ledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
- Do not use your appliance in a dusty room or a room where there is a risk of fire.
- This appliance is intended for domestic use only. It must therefore not be used in industrial applications.
- The warranty will be void in the event of damage arising from improper use.
- If the power cable is damaged, it must be replaced by the manufacturer, its after-sales service or a person with similar qualifications to avoid any danger.
- Do not place the unit directly beneath an electrical outlet.
VERY IMPORTANT
- WARNING: In order to avoid overheating, DO NOT COVER THE HEATER.
- Do not use the unit in the proximity of flammable objects or products (curtains, aerosols, solvents, etc.)
- Never use the unit in an inclined or horizontal position.
- Do not use this appliance near a bath, shower, sink or swimming pool.
- NEVER ALLOW WATER TO PENETRATE THE APPLIANCE.
- Do not touch the appliance with wet hands.
- In the event of a long absence: turn the button A to the initial settingand unplug the appliance.
- However, the electrical installation in the room, the installation of the unit and the way the unit is used must all comply with the safety standards in force in your country.
USE IN THE BATHROOM (PROTECTION AGAINST SPLASHING WITH WATER)
This “IP21“ unit has been specially designed so that it can be used in any room in your house, including those where there is a risk of water being splashed onto it from above (kitchen, bathroom, etc.).
VOLTAGE
- Before first use, make sure that the voltage being used corresponds to what is indicated on the unit and that the electrical installation is adapted to the power level indicated.
- Your appliance can be used with a power plug without an earth connection. It is a class II appliance (dual electrical insulation
SAFETY
Heat safety
In the event of abnormal overheating, a safety device shuts down the appliance and then automatically restarts it once it has cooled. If the fault persists or gets worse, a thermal fuse shuts the appliance down definitively and it must then be taken to an approved service centre.
OPERATION
Before turning the unit on, make sure:
- it is positioned as described in these instructions,
- that it is placed in a flat and horizontal position, and;
- that the air intake and outlet screens are free of all obstacles.
Function Selection:
Select the desired function by turning switch (A) to line up the marking on
the switch with one of the following symbols:
- Off
- Silence” 1200W
- 2400W
Indicator
On/Off indicator C, lights up when the unit is turned on.
Thermostat
Adjust the temperature setting, according to your own comfort, by turning
button B.
Frost-free setting
This setting enables you to automatically maintain the temperature above 0°C
in a normally insulated room, whose volume corresponds to the power of your
appliance. Plugin the unit and turn switch B to line up the marking on the
switch with the ” ” symbol. Turn switch A to select one of the following
CLEANING
- Your appliance must be unplugged before proceeding with any cleaning work.
- You can clean it with a slightly damp cloth.
- IMPORTANT: Never use abrasive products which might damage the appearance of your appliance.
- We recommend that you clean the air inlet and outlet grills at least once a year; (clean with a vacuum cleaner if necessary).
STORAGE
- It is extremely important that the unit be allowed to cool down before it is put away.
- When storing your appliance, you can wind the lead around the stand and clip the end into the lead clip (G).
- When you are not using your appliance, store it in a dry place.
IN THE EVENT OF PROBLEMS
- Never dismantle your appliance yourself. A poorly repaired appliance may be dangerous for the user.
- Before contacting one of our Approved Service Centres, ensure that:
- the appliance is set to normal operating mode;
- the air inlet and outlet grills are totally clear.
ENVIRONMENT PROTECTION FIRST!
Your appliance contains valuable materials which can be recovered or recycled. Leave it at a collection point.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>