Shenzhen Yiweida Technology YL012 Underwater Camera User Manual
- June 5, 2024
- Shenzhen Yiweida Technology
Table of Contents
Underwater Camera
Operation manual
Please study the manual carefully and diligently before using our products.
Product Introduction
- Products Accessory
- Products Details
Download APP
You need to download the iOS app or Android app to connect to your lure
fishing camera.
Download for Android:
- Please search for XiLiHaLa in the Google Play Store to download and install
- Scan the QR code below to download and install the APP
https://play.google.com/store/apps/details?id=com.cp.fishgear
Download ISO
- Please search for XiLiHaLa in the App Store, download, and install
- Scan the QR code below to download and install the APP
https://apps.apple.com/app/xilihala/id1620282083
Turn on /Turn Off
-
Turn on: The camera would automatically turn on after throwing it into the water for 3 seconds, and then enter into the recording state; (green light flashing)
(In places where there is no water on the shore, you can touch the charging port with a wet paper towel or touch your finger with water for 3 seconds to automatically turn on) -
Turn off: The camera would automatically turn off after 30 seconds of leaving the water;
(When the battery is low during usage, the green light will flash quickly for 5 seconds, and then the camera turns off; the Will is connected before leaving the water, the camera will always be turned on, and if the WIFE is disconnected. the camera would turn off after 30 seconds.)
Notice: The WIFI needs to connect within 3 minutes after the camera turns on, otherwise the WIFI will automatically turn off. -
Any unknown reasons for the crash, please use the magnetic charging cable close to the reset position for the rest of the canter
Indicator light
- Blue light: Flashing indicates that the connection is in progress; long bright means the WIFI is connected; off means, WIFI is closed;
- Greenlight: Long bright for standby; flashing for recording; fast flashing for 5 seconds and then shutting down; fast flashing for TF card abnormality;
- Red light: Flashing means charging; Long bright means Fully charged.
Working status
| Blue light| Greenlight|
Red light
---|---|---|---
WIFI disconnection| flash| —| —
WIFI Connection| Long Bright| —| —
WIFI turn of| Light extinct| —| —
Standby| –| Long Bright| —
Recording| —| Flash| —
Low Battery| —| |ast | ash 5sec and then turn off| —
Charging| —| —| Flash
Full Charging| —| —| _ong Bright
TI card Abnormal| —| fast flash| —
Charging
Aim the magnetic suction wire to the charging port of the camera to charge,
the red light flashes when charging, and the red light stays on when fully
charged.
If the red light does not flash when the magnetic suction line is connected to
the machine:
- Checking that the 5V power adapter is working;
- Check whether the charging port of the machine is dirty or covered by foreign matters. and reconnect it after cleaning;
- Reset the magnet end of the magnetic suction line to site reset the position of the machine, and then charge. If the red light does not that try to keep the device Reset the magnet cad of the magnetic suction line to the reset position of the machine, and then charge. If the red light does not flash, try to keep the device powered on for one hour, and then reset to see if the battery is charging powered on fur one hour, and then reset to see:
- The environment is at a very high or very low temperature, wait until the temperature has returned to a suitable level and try charging again;
- It can be charged when the battery is over-discharged or when the battery temperature is too high or too low, but i: may take several hours to complete a normal charge.
APP Operation
After downloading and installing the APP, connect to the machine as follows:
- After the machine is turned on, open the phone WIFI; find the WIFI network prefixed with “Fishing cam_****”, enter the default password: 12345678, then click connect
- Open the l’XiLiHaLil APP on your mobile phone and enter the main interface of the API’ for operation
APP Setting Menu
No.
| Item| Parameters|
Default
---|---|---|---
1
|
Record Sound
| ON/OFF|
OFF
2
|
Recording Watermark
| NO/OFF| OFF
3
| Videos Resolution| 1080P 720P (60fps)|
1080 P
4
|
Recording time
| 2 min/3 min/5 min (Loop recording)| 3 min
5
| Forma.| YES/NO|
—
6
|
System Reset
| YES/NO| —
7
| APP Version| Cu rrent APP version|
—
8
|
FWVersion
| Current FW version Number|
—
Cautions
- Vaal the equipment is splashed wah decagon, soap, hot spring, bath additives, sunscreen, chemicals, etc, please immediately. If it is used in saltwater. please wash it in clean freshwaters, such as tap water(t1w waterproof function of this equipment is only applicable to seawater and had to water)
- If then: are foreign [natters such as liquid. dust and lint attached to the equipment. please wipe them with thy and soft cloth.
- Do mil toe chase to the magnet to avoid the Nod and shutdown of the machine.
- Using this equipment underwater:
- Do not use it at a depth of more than 50 meters
- Please use the equipment when the water temperature is between – 5 ° C and 40 °C (23F — 104F) (please do not use it in the bathtub or hot spring):
- Do not use it continuously underwater for more than 3 hours:
- Do not impact the equipment underwater. (waterproofing may not be maintained and water leakage may occur);
- Do not use this equipment in places with strong water flow. such as rapids or waterfalls. Strong water pressure may be applied and may cause failure; This equipment will sink in the water. Be careful of losing it.
Maintain the equipment after use:
- De sire to clean the equipment after me. Do not leave it idle for mom than 60 minutes. Foreign matters or saltwater left on the device may cause damage, discoloration, corrosion, peculiar: midi or dOcriuration of waterproof performance
- After being used by the sea or underwater. soak the equipment in fresh water in a shallow container for about 10 minutes. wipe off the water drops on the machine with a soft thy cloth, and dry the machine in a well ventilated and cool place;
- Dry the machine with a dust-free cloth. Do not thy it with the hot air of a dryer or similar equipment, which will deteriorate the waterproof minim: ace or cause failure due to deformation:
- Do not use benzoic, diluent, alcohol, or chemicals such as detergent, soap, or detergent to clean the equipment;
- When used la temperatures below Cr32F. the performance of the battery (recording time working time) may be temporarily reduced. Before use ensure that the battery is fully charged, and the battery cannot be charged at a temperature Iowa than 0° C / 32F;
- 1f the device continues to be used in cold areas, such as ice fishing, northeast wakes, skip woo-, winter climate, or high altitude, the batten life and total product of the device may decrease over time:
- After the equipment eaters the water. the Will signal between the mobile phone and the equipment will be interrupted. Please place the equipment on the Acre when downloading and prelim. ing the recorded video;
- Do not place the equipment in the vehicle for a long time, so tau it can be directly exposed to the sun when the doors and windows are dosed.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. ct.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.
Shenzhen Yiweida Technology Co.Ltd
Mail: service@xilihala.cc
Made in China