DYNAZAP DZ30300 Replacement Bulb Owner’s Manual

: June 5, 2024
: DYNAZAP

Table of Contents

DZ30300 Replacement Bulb
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DZ30300 Replacement Bulb

DZ30200/DZ30300
OWNER’S MANUAL

OUTDOOR ALL-WEATHER CONSTRUCTION RAIN OR SHINE

Thank you for purchasing

DYNAZAP®!

This product may be covered by one or more U.S. patents or pending patent applications. See www.DynaTrap.com/patents

IMPORTANT: READ CAREFULLY IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS

WARNING: when using electric appliances, basic precautions should always
be followed, including the following:

Please read all instructions before using the DynaZap® Insect Zapper and keep for future reference.
To disconnect, remove plug from outlet.
To reduce the risk of injury from electric shock, always turn unit off and disconnect
plug before servicing or cleaning.
Always unplug before replacing lamp. Replace with same type rated 40-Watt bulbs,
DynaZap® model 30300. Skin or eye damage may result from directly viewing the light produced by the lamp in this apparatus.
Do not position the unit near heat, gas, oil or other flammable materials.
Store products indoors when not in use – out of reach of children.
To reduce the risk of electrical shock, do not put appliance in water or other liquid.
Never operate this product if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or if it has been dropped into water or other liquid.
Connect only to a circuit that is protected by a ground-fault circuit-interrupter (GFCI).
Do not insert fingers or any foreign objects into the unit while it is connected to an electrical outlet.
Collected insects within the unit may contribute to fire, so clean insects from the unit frequently.
Do not clean this product with water spray. Do not place where it can fall into water, or near flammable materials.
Do not touch electrical grid while plugged in.
Do not abuse cord–never carry or hang unit by cord or yank it to disconnect from receptacle. Keep cord away from heat, oil, and sharp edges.
Use only extension cords marked with “W-A” and a tag stating, “Suitable for Use with Outdoor Appliances.” and rated equal to, or greater than product electrical rating.
Use only extension cords that have plug and receptacles that match the product plug. Replace or repair damaged cords.
Only use attachments recommended or sold by the manufacturer.
Use extension cord marked SJW-A, SJEW-A, or SJTW-A only.
This appliance is not intended for use by children and other persons whose physical, sensory, or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely.
Children should be supervised by the responsible person to ensure that they do not play with the appliance.
WARNING: An electric shock hazard may exist if water from a garden hose is directed at the insect killer. When using extension cords, keep the socket-outlet away from moisture and avoid damage to the cord.
The appliance is not to be used in locations where flammable vapour or explosive dust is likely to exist.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

INSTALLATION & OPERATING INSTRUCTIONS

Unpack unit. Save carton for off-season storage (if needed).
If hanging the unit, place it approximately 6 feet above floor or ground for optimal performance and easy access for cleaning.
Plug in to power device ON.
For best results, leave unit on at all times, except when cleaning or servicing.
Insect activity will be higher at night. For best results, place unit away from other competing light sources.
It is recommended to place the unit 20 – 40 feet away from where people will be sitting.
This unit is all-weather resistant designed for outdoor use including rainy conditions. Intended for outdoor use only.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. USER

MAINTENANCE – ANY SERVICING OTHER THAN CLEANING AND BULB MAINTENANCE SHOULD BE PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE.

Frequent cleaning will prolong the life of the unit, ensure fire prevention and provide for more efficient operation.

UNPLUG UNIT from outlet to power off before cleaning.
Remove the 4 screws from the bottom of the unit to release the access door.
Gently tap unit to get insects to drop out of the bottom of the unit. If available, a leaf blower, vacuum, or similar device can be used to remove insects.
After cleaning, replace access door and reinsert 4 screws securely.
Clean before off-season storage. HOW DYNAZAP WORKS Flying insects are instinctively attracted to the DynaZap® by the UV light. Once attracted and drawn into the unit, the insects come in contact with the electrified grid where they are zapped and killed.

REPLACING BULBS REPLACE WITH DYNAZAP® BULBS #30300 (OR EQUIVALENT GR10Q

TYPE – 120V / 40W UVA BULBS)

The light bulb life expectancy is approximately 3,000 hours (or about 4 months), and should be replaced regularly to ensure optimal UV effectiveness. Even though the bulb’s light may be visible to you, it’s ability to attract insects diminishes over time.

UNPLUG UNIT from outlet to power off, and allow bulbs to cool before replacing.
Remove the 4 screws from the bottom of the unit to release the access door (A).
Cover hand with towel and gently pull bulb/bulbs straight out of unit (B).
Insert new bulb/bulbs into socket until it is fully seated.
After changing bulb/bulbs, replace access door and reinsert 4 screws securely.

REPLACEMENT PARTS

30300 1, 40-Watt UV Replacement Bulb To see all replacement and accessory parts available, visit www.DynaTrap.com.

FCC COMPLIANCE

This device complies with part 18 of the FCC rules. This product may cause interference to radio equipment and should not be installed near maritime safety communications equipment or other critical navigation or communication equipment operating between 0.45-30 MHz. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

TROUBLESHOOTING

Problem:

Possible cause:

Correction:

---|---|---

Bulbs do not illuminate and grid does not zap.

No electrical power.

1. Check plug, receptacle, and fuse or circuit breaker.

Bulbs illuminate, but grid does not zap.

1. Contaminated grid

2. Damaged high voltage circuit

1. UNPLUG UNIT: Clean grid as listed in “cleaning” section of manual; retest.

2. If unit still does not zap after cleaning, High-voltage circuitry dam aged – Unit Defective. Contact customer care at 1-877-403-8727 or dynatrap@woodstream.freshdesk.com for assistance.

Grid zaps, but bulbs do not illuminate.

1. Bulbs not seated properly. 2. Burnt out bulbs.
3. Damaged bulb driver

1. Check all sockets for proper bulb seating and alignment.

2. Replace bulbs if needed following instructions under “Replacing Bulbs” section of manual.

3. If unit still does not illuminate after replacing bulb: Bulb driver circuitry damaged – Unit Defective. Contact customer care at 1-877- 403-8727 or dynatrap@woodstream.freshdesk.com for assistance.

LIMITED WARRANTY

Woodstream Corporation guarantees to the original purchaser that this product is free from defective materials and workmanship. This warranty is limited to remedy any defective part for a period of one year from date of original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply to the light bulb, nor to, in our judgment, misuse or abuse. If this unit has been altered, no warranty is in force. This warranty does not apply if this unit is purchased outside the United States, Canada and Mexico. In no case shall Woodstream Corporation be liable for any accidental, punitive, consequential, or any other damages of any kind for breach of this or any other warranty, expressed or implied, whatsoever. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

SAVE THESE INSTRUCTIONS

Woodstream Corporation 69 N. Locust St., Lititz, PA 17543 1-877-403-8727 (TRAP) www.DynaTrap.com
Imported by: Woodstream Canada Corporation 25 Bramtree Court, Unit 1 Brampton, ON L6S 6G2 www.DynaTrap.ca
dynatrap@woodstream.freshdesk.com
© Woodstream Corporation

FOR OUTDOOR USE ONLY

DZ30200: 120 V~ 60 Hz 30 W 0.40 A DZ30300: 120 V~ 60 Hz 45 W 0.56 A
This device complies with Performance Standards for Light-Emitting Products, 21 CFR, Part 1040, Chapter 1, Subchapter J, Radiological health.

A001-466.2021.4

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual >>