GLUCKLUZ LED Lighting Strip TV Back Light 2M Strips Lights User Guide
- June 5, 2024
- GLUCKLUZ
Table of Contents
GLUCKLUZ LED Lighting Strip TV Back Light 2M Strips Lights
Remote Control
- On/Off switch
- White light (mixed color)
- Flash (fiashing function)
- Strobe (slow fading out of a color)
- Fade (slow fading out with color change)
- Smooth (smooth color change)
- Control panel for color selection (12 mixed colors)
- RGB setting (red, green, blue)
- Increase/decrease the intensity of color
Installation
- Clean the surface you intend to stick the light strip to.
- Peel off the backing strip off the 3M adhesive tape.
- Press and hold the light strip firmly against the surface.
- Remove the tab from the battery compartment of the remote control.
- Connect the USB cable to the USB port on a TV or a USB wall charger (1 A charger required – not included).
Changing the remote control battery
The battery for the remote control has already been installed. You only have remove the battery pull tab to operate.
- The battery compartment is located on the narrow side of the remote control. Pull it out as shown.
- Remove the empty battery and insert a 3V battery, type CR2025. The positive terminal must point upwards.
- Place the battery compartment back in the remote control so it locks in place.
For optimal performance:
Place IR receiver in a location away from the IR receiver on the TV to avoid
interference from the TV remote control.
Operation
- Turn on the LEO Backlight by pushing the ON button on the remote control.
- Select the desired color or the desired effect and push the corresponding button on the remote control. Please note that the color settings are mixed colors. For this reason the color tints may exhibit minor deviations. Even white light is a mixed color and thus not a purely white color tint.
- Set the desired color brightness using the buttons to increase/decrease the intensity of color.
- Push the OFF button to run off the LEO backlight.
Technical data
- Voltage supply: LEO strips (USB)
- Remote Control 3V (1 x 3V battery, type CR2025)
- Output: 5V 2.SW
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>