PLAYLEARN 6151B Fiber Optics Wireless Speaker Lamp Instructions
- June 5, 2024
- PLAYLEARN
Table of Contents
PLAYLEARN 6151B Fiber Optics Wireless Speaker Lamp
Instruction
How to Play:
- Press the switch”-” at the bottom of the product then the LED glitter lamp hear a “do-do-do-do” prompt tone which means the bluetooth is ready.
- Turn on the bluetooth settings of your mobile and search and link in bluetooth JR-006. It has been connected successfully once you hear the prompt tone of “di-do”.
- Press the switch’0″ at the bottom of the product then the LED glitter lamp and blue tooth will be turned off.
- Please recharge the battery with the USB cable when you hear the low battery warning.
The audio effect and lamp will be weaker if the battery is low. will be turned on and you will Bluetooth name: JR-006 Bluetooth version: 5.0 Frequency band: 2402MHz to 2480MHz Transmission distance: 10 M Loud speaker: 4 2 3w sized45mm Battery: 3.7v 18650 1200mAh Charging time :2-3hours, Workingtime :5-6hours Charging indicator: Green light=full power,Red light=low power Low Battery Warning: prompt tone “do-do-do”
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with thelimits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note : The Grantee is not responsitble for any changes or modifications not expressly approved by the party responsible for compliance. such modifications could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. This device and its antenna(s) must not be co- located or conjunction with any other antenna or transmitter