LEDeez LE-SHOW-BLU Splash LED Wireless Speaker Instruction Manual

: June 5, 2024
: LEDeez

Table of Contents

LEDeez LE-SHOW-BLU Splash LED Wireless Speaker
MANUAL Charging the Bluetooth speaker
Operating the Bluetooth speaker
safety and care instructions
Fcc Statment
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LEDeez LE-SHOW-BLU Splash LED Wireless Speaker

MANUAL Charging the Bluetooth speaker

Please make sure battel)’ is fully charged before initial use.
To charge your Splash LED Wireless Speaker, connect the supplied Micro USB cable to the Micro-USB charging port and connect the other end to a USB power outlet (5V adaptor not included). LED indicator wm illuminate RED to indicate that the speaker is charging.
Allow approximately 3-4 hours of charging time to fully charge the speaker. When battel)’ is fully charged, the LED will turn off.

Operating the Bluetooth speaker

Turn the Bluetooth Speaker ON by holding down the power button (1) for Two Seconds. The speaker LED ring will be white light and tone prompts you the device is in pairing mode.
Enable Bluetooth search mode on your smartphone and select pairing name “LE-SHOW’ on your Bluetooth device list Once the speaker has successfully connected, you’ll hear a beep
To change the LED ring’s color. press the “bulb” button(2).
To Power down the Speaker, hold down the start button
for Two Seconds. The LED ring will shut off.

safety and care instructions

Do not attempt to disassemble the unit
Repairs to electrical equipment should only be performed by a qualified service person. Improper repairs may place user as risk and void warranty.
Do not puncture or harm the exterior surface of the product in any way.
Do not drop or let the unit fall from high places.as doing so may damage the device.
Do not use this unit for anything other than its intended use or purpose. Doing so may damage the device and void warranty.
This product is not a toy. Keep out of reach of children.
Do not expose batteries or battel)’ pack to excessive heat or open flame.
Do not expose the unit to extremely high or low temperatures as this will shorten the life of the device, destroy the battel)’, and/or distort certain parts.
Do not use abrasive cleaning solvents to clean the unit. In order to prolong battery life, turn oft when not in use.

Fcc Statment

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment oft and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/IV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.

BT ID