kbice FDFM1JA01 Self Dispensing Nugget Ice Machine User Guide

Self Dispensing Nugget Ice Machine
Quickstart Guide — Model: FDFM1JA01

INSTALLATION REQUIREMENTS

Clearance Requirements
CAUTION

• This unit is designed for countertop use only.
• Never block the air vent on the left side.
• This unit is designed to be in operation in an area with a maximum ambient temperature of 80°F, 26°C. Warmer ambient temperature will result in reduced ice quality and product.
• Never operate this unit in direct sunlight.
• Allow for a minimum clearance of 12 inches on the left side, ½ inch on the right, 2 inches on the back, and ½ on the top of clearance on the left side, to ensure proper  function of the unit.

Scan here for instructional video:

http://youtube.com/watch?v=Vr3lmwV2BZA&feature=youtu.be

1.  Display Panel
2. Ice Dispense Point
3. Water Port for Funnel
4. Reservoir Cover
5.  Air Vent
6.  Water Drip Tray
7. Power Cord
8. Drain Tube Plugs/Holder

Electrical Requirements

DANGER
It is required that you connect this unit only to a GFCI protected receptacle. It is strongly recommended that you do not use an adapter to connect this unit because of safety hazards.

Water Requirements

WATER
We recommend using distilled, bottled OR filtered water, as this will improve the performance of the machine. Tap water with a hardness of <100 PPM is also acceptable. The
machine will NOT produce ice and will automatically go into clean mode if tap water with a hardness > 100 PPM is used
NOTE
Do NOT add water until Water Level red LED flashes. Do NOT overfill the reservoir, otherwise it may overflow when ice melts completely.

USE OF DISPENSER

1. Filling the water reservoir for the first time use

• Remove the reservoir cover by simultaneously pulling from the left and right side towards you
• Add water to MAX WATER FILL and then replace cover.
• Do not plug in until you have filled water to max fill line
• Plug unit into power

2. Flushing the unit for the 1st time

• Plug the unit into power.
• Press and hold Clean button for 3 seconds to start the Cleaning mode
• Unplug the unit when the flushing process is complete (it takes 30 minutes and the Cleaning LED goes off).
• Pull the drain tubes with plugs/holders out of the unit back and remove the plugs/holders to release water.
• Replace the plugs/holders and put the tubes with plugs/holders back to the unit.

3. Making ice for the 1st time. IMPORTANT

• We recommend using distilled, bottled OR filtered water, as this will improve the  performance of the machine. Tap water with ahardness of <100 PPM is also acceptable. The machine will NOT produce ice if tap water with a hardness > 100 PPM is used
• Unplug the machine
• Remove the reservoir door and fill the machine by sight to the max fill line, located on the back of the water reservoir.
• Replace the cover and plug the unit into power.
• Press Make Nuggets button once and wait for the Making Ice LED to flash slowly

FIRST TIME USE
Dispense several cups of ice and discard them.

4. Using the funnel

• Insert funnel into the water port
• Add distilled, bottled OR filtered water until the Water Level LED button illuminates in green. You will hear 5 beeps.
• Remove the funnel to close port

Note: Funnel is Packed Inside the Reservoir

www.kbgoodice.com
©KB Ice & H²0, LLC
Updated 2/8/21

Documents / Resources

| kbice FDFM1JA01 Self Dispensing Nugget Ice Machine [pdf] User Guide
FDFM1JA01, Self Dispensing Nugget Ice Machine
---|---
| kbice FDFM1JA01 Self Dispensing Nugget Ice Machine [pdf] Instructions
FDFM1JA01, Self Dispensing Nugget Ice Machine, Nugget Ice Machine, Ice Machine
| Kbice FDFM1JA01 Self Dispensing Nugget Ice Machine [pdf] Instructions
FDFM1JA01 Self Dispensing Nugget Ice Machine, FDFM1JA01, Self Dispensing Nugget Ice Machine, Nugget Ice Machine, Ice Machine, Machine

References

• KB!ce™ Self-dispensing Nugget Ice Maker

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>