HUMMINBIRD 532888-2 MEGA Live Imaging Transducer Instructions
- June 5, 2024
- Humminbird
Table of Contents
REDUCE DOUBLE IMAGES USING A MEGA LIVE MASK
532888-2_B
Determine Whether to Install the Mask
When operating your MEGA Live Imaging transducer under certain conditions and at higher angles (40° to 60°) in forwarding Mode, your sonar return may include faint double images caused by the beams bouncing off the surface of the water. If you are repeatedly experiencing double images, apply an included mask to your transducer using the following instructions.
Install the Mask
Use the instructions below to apply your mask. For additional information, a video tutorial is available at https://humminbird.com/mega-live-starter- guide.
-
Determine the transducer angle you will be using most frequently (see your MEGA Live Imaging operations manual for more information). For use at 50° or 60°, use a long mask (7/8″). For use at 40°, use a short mask (1/2″).
If you plan to switch between angles frequently, Humminbird recommends using the short mask (1/2″). -
Clean your transducer with rubbing alcohol. Remove the backing from the mask and press the adhesive side firmly into place against the side of the transducer that will face up (as shown in the illustration MEGA Live Mask Placement).
NOTE: The side of the transducer that will face up is dependent on whether the transducer is installed on the port or starboard side of the trolling motor. Two sets of unique port and starboard masks are included with your accessory. Each set is contoured to fit one side of the transducer.
MEGA Live Mask Placement
Contact Humminbird
Contact Humminbird Technical Support through our Help Center at <https
://humminbird-help.johnsonoutdoors.com/hc/en-us>.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>