LUTEC 7635202053 2 Head 250 Watt Equivalent Integrated LED Instructions
- June 5, 2024
- LUTEC
Table of Contents
LUTEC 7635202053 2 Head 250 Watt Equivalent Integrated LED
Please read and understand this entire manual before attempting to assemble, operate, or install the product.
WARNING
-
Consult a qualified electrician if you are not certain about the installation process. Always install wiring connections in accordance with the local code, ordinances, and the National Electric Code.
-
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
-
Do not attempt to install this product while it is plugged in.
-
Do not connect this light fixture to a dimmer switch or timer.
-
This light fixture is designed to fit standard junction boxes as defined by the National Electrical Code.
To avoid water damage and the risk of electrical shock, the motion sensor controls must be facing the ground when installation is complete. -
Do not install motors, transformers, or fluorescent light fixtures on the same circuit as the fixture.
| OPERATION | “TIME” Setting | “DISTANCE” Setting | DESCRIPTION |
|---|
TEST MODE
|
TEST
|
Any setting
| Tests the sensor’s functionality even during daylight hours. After motion
stops, the light will remain on full brightness for 5 seconds and then turn to
low brightness.
| 1, 3, or 10 (minutes)| L, M, or H|
MOTION DETECTION (WITHOUT
DUSK TO DAWN)
| Adjusts how long the light stays on after detecting motion before shutting off.| L= 0-20 ft.
M= 20-39 ft.
H= 39-59 ft.
Adjusts how far the sensor detects motion.
| Turns on at night only when motion is detected. Deactivates during daylight hours.
MOTION DETECTION (WITH DUSK TO DAWN)
|
1, 3, or 10 (minutes)
Adjusts how long the light stays on after detecting motion before shutting off.
|
“D2D”
Sensor defaults to 39-59 ft. coverage when set to “D2D”.
|
Turns on at night and stays on at low brightness, then turns to full brightness if motion is detected.
Deactivates during daylight hours.
Manual Override: Force the fixture to override the TEST, SECURITY or DUSK TO
DAWN mode so the light will stay on. Turn the light on manually from the wall
switch. With the fixture already in the ON position, continuously f lip the
wall switch off and then back on twice in 3 seconds.There are three ways to
revert back to the previous mode:
Once again flip the wall switch off, wait for more than 3 seconds and then
turn back on. If you leave the light on, the light will stay on for about 6
hours, then return.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>