HACHANLUN B085LXCFSM RFID NFC Card Copier Reader Writer Duplicator User Manual
- June 5, 2024
- HACHANLUN
Table of Contents
HACHANLUN
B085LXCFSM RFID NFC Card Copier Reader Writer Duplicator
User Manual
China association of locksmith designated recommended products
Designed specifically for Locksmiths
USER MENU
Important Note for Device Users: please read the instruction before operating. If you do not use this product for a long time, please remove the battery and keep it cool and dry where they are stored.
Function
Support read-write Frequency:
125KHz.250KHz, 375K1-1z.500KHz,
13.56MHz(IS01443A/B)
Voice prompt
2.8′ LCD display
Internet upgrade
Parameters
Input voltage : MICRO USB DCSV or 4AA batteries
Standby power consumption: 50uA
Working power consumption: 120uA
Size: 180X70X30mm
Instructions
Press Scan and enter the ‘smart cards page’, The key card in the induction
area, press ‘scan, the reader successfully.
Replace the blank card with the induction area, Press.’ write’ Copied
successfully
Decode
Use ZX-COPY decoding software IC card: The device is turned into the ‘disclaimer page’, the Micro USB cable to connect the device with the PC. PC appears U disk, open U disk inside the ZX-COPY decoding software, and press ‘OK’ to enter the main interface of the device.
For the IC card on the induction area, click on the Start decoding software. After decoding is successful, the replacement of a blank card to the induction area, according to the ‘Write’ success writing cards, is copied successfully.
Connection
With a Micro USB cable to connect the device with the PC. When PC lower-left corner decoding mode, the device indicates a successful connection. Click ‘start’ to oper decoded.
After the device is connected PC, click on the bottom right corner of the
upgraded version.
Automatically searches for the new version, click Upgrade. Click the lower
right corner of PC Help to learn more information about this device.
Functions diagram
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>