KLUGMIA B08 Bluetooth Kids Headphones User Manual
- June 5, 2024
- KLUGMIA
Table of Contents
B08
Specifications
Working Range: 12m Battery voltage:3.7V Battery Charging Voltage: DC5V Charging Time: about 2.5 H Working Time: about 24H Impedance: 32-ohm Volume control: 85/94dB Speaker diameter: 40mm
Button Function
- ” ” Power on/Power off
- ” +” Volume up: short press Move next: long press
- “-” Volume down: short press Move previous: long press
- Power on: Long press ” ” for more than 2 seconds, the headphone turn on and enter Bluetooth Mode. The blue and red lights flash alternately.
- Power of the Long press” “for more than 2 seconds, the LED indicator light is off and the headphone turns off.
Calling
- Hang on: Short press the” ” button when being called.
- Hang up: Short press the” ” button when calling.
- Dial back: Double click the” ” button.
- Play music: Normally short press the” ” button to turn on the smart devices automatically to play music.
- Continue to play music after the call: When there is an incoming call, the music will be automatically suspended. After the call, you need to short press the ” ” button to continue playing.
Pairing
- Turn on the Bluetooth of your phones or other Bluetooth devices.
- Turn on the headphones, and the headphones enter Pairing mode (indicator flashes red and blue alternately).
- In the list of found Bluetooth devices in your phone or other Bluetooth devices, choose ”Kids Joy” to Pair.
Notes:
Subsequent pairing : 3 seconds after powering on, it will automatically search
and connect the smart device which paired last time Power saving mode: headset
will automatically power off after pairing continuously for 5 minutes;it will
cut off the power supply automatically after using an Aux-in cable for power
saving.
AUX-in Mode
In any mode, insert the AUX-in line, the headset automatically shut down, and
switch to the AUX-in function without power consumption.
LED indicator
Charging| The red light is on when charging, and the full charge indicator is
off
---|---
Powering on| Blue LED is on
Powering off| The LED f turn to off
Pairing| Blue and red LED flashes alternately
Connected| Blue LED flashes
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Volume control
The default volume of the headset is 85dB. Press and hold the dB button for
two seconds, and then the volume will switch to 94dB after the beep.
At 94dB, press and hold the dB button for 2 seconds and then the volume will
be adjusted to 85dB after the beep.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur in a particular installation. If the equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This device should be installed and operated with a minimum distance 0cm
between the radiator&your body.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.