NICOR DQR2-10-120-2K-WH-BF 2-Inch Square LED Downlight Instruction Manual
- June 5, 2024
- NICOR
Table of Contents
NICOR DQR2-10-120-2K-WH-BF 2-Inch Square LED Downlight
INSTALLATION
WARNING: These products may represent a possible shock or tire hazard it improperly installed or attached in any way. Products should be installed in accordance with these instructions, current electrical codes and/or the current National Electric code (NEC)
CAUTION To reduce risk of fire, electric shock or injury to persons:
- Make sure that the electrical power to the fixture is disconnected prior to any installation or retrofit.
- This light is suitable for damp, wet locations.
- Use with 2″ recessed cans (recessed housing) only. Do not attempt to alter for other sizes or purposes.
- For best dimming results, use standard incandescent wall dimmers in a branch circuit that is supplied with 120V AC power. Check dimmer manufacturer’s specifications to confirm whether minimum loads apply
WARNING
Risk of fire or electric shock. Install these kits only in luminaires that
have the construction features and dimensions shown in the illustrations There
in (2″recessed housings) Confirm this before installation by checking the
interior of the housing for a manufacturer’s part number and specifications,
or measure the diameter of the housing. The recessed housing must have a
minimum measured inside diameter (opening) of 3/4″; maximum diameter 3/2″;
minimum inside clearance of 33/4″. See Figure 1. Do not make or alter any open
holes in a wiring enclosure nor in any electrical components during kit
installation!
WARNING: Risk of fire or electric shock. Kit installation requires
knowledge of recessed lighting luminaires’ electrical systems. If not
qualified, do not attempt installation. Contact a qualified electrician. Do
not use these products in luminaires located where elevated ambient
temperatures exist.
WARNING: Risk of fire or electric shock. The electrical rating of this
product is 120V Ac. The installer must determine whether the power supply is
120V AC at the luminaire before installation. (120V/277V Ac 50-6OHz is
available if 120V/277V is indicated on the caution label)
WARNING: Risk of fire or electric shock. Luminaire’s wiring, ballast(s),
or other electrical parts may be damaged when drilling for the installation of
reflector kit hardware. If drilling is required in any installation, check for
enclosed wiring and components and be careful to protect them from any harm.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE
WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE
CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
Each fixture includes a socket adapter for use with a standard 120V medium (E26) base socket adapter, a pair of torsion spring clips. See Figure 1
RETROFIT INSTALLATION
- Always make sure power to textures is disconnected before beginning removal of existing trim or retrofit installation.
- Remove existing lamp, trim, and socket plate from the housing.
- Disconnect the orange-colored connector on the fixture (FIG 2).
- Assemble E26 socket adapter to existing socket come down from housing.
- Connect the orange-colored connector on the fixture.
- Push fixture gently to the ceiling until seated (FIG 3).
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>