TROLL 000641 Lukas Mini Cot Instruction Manual
- June 5, 2024
- TROLL
Table of Contents
TROLL 000641 Lukas Mini Cot
SAFETY INSTRUCTIONS
Your child’s safety is your responsibility.
Remove all parts from the packaging and check against the parts list.
Do not discard any packaging until you are sure you have all parts and the
pack of fittings.
You will find it easier to assemble the cot if a second adult is available to
help you.
WARNING: Be aware of the risk of open fires and other sources of strong
heat, such as electric bar fires, gas fires etc in the near vicinity of the
cot.
WARNING: Do not use if any part of the cot is broken, torn or missing and
use only spare parts approved by the manufacturer.
WARNING: Do not leave anything in the cot or place close to another
product, which could provide a foothold or present a danger of suffocation or
strangulation e.g. strings, blind/curtain cords etc.
WARNING: Do not use more than one mattress in the cot.
One end of the cot has a mark indicating the maximum height of the mattress.
The thickness of the mattress must not reduce the internal depth from mattress
surface to top of the cot side above it to less than 500 mm in the lowest
position and 200 mm in the highest position of the mattress base.
The lowest mattress base position is the safest and should always be used as
soon as the baby is old enough to sit up.
Mattress base length and width shall be such that the gap between the mattress
and the sides and ends does not exceed 30mm.
The recommended mattress size for the cot is 1 x 0 cm and maximum thickness 10
cm. Check regularly to ensure that all the components are secure and retighten
as necessary.
To prevent injury from falls, when the child is able to climb out of the cot,
the cot shall no longer be used for that child.
To clean use a damp cloth, avoiding the use of strong detergents or abrasives.
CUSTOMER ENQUIRIES
PARTS LIST
FITTINGS LIST
TOOLS REQUIRED
ASSEMBLING
Insert screws B for fitting mattress base in
one of three height positions.
WARNING! To Top of the matter, the surface must not be higher than this mark!
Do not tighten screws A.
Drop mattress base onto screw-in dowel pins. Tighten the cams on the front
underside of the mattress base using a crosshead screwdriver.
Tighten screws A.
Attach the wheels.
ASSEMBLING – SOFA
WARNING!
”SOFA” is designed to use for children!
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>