TOLLCO 5902011-1 Diaflex Dishwasher Installation Guide
- June 5, 2024
- TOLLCO
Table of Contents
5902011-1 Diaflex Dishwasher
Installation Guide
Installation Diaflex
Installation Instructions Diaflex
-
Perforation, use hole saw T80 = Ø84mm. The hole is placed at least 25mm from the back, sidewall, and pipe.
-
Press the spike, and remove the hose holder.
-
a) Machine connected to water, b) Power cord, c) Solenoid valve, d) drain hose.
-
e) Correct position of the solenoid valve, the valve must be outside the frame. Press the nut through the rubber membrane.
f) Press in the solenoid valve inside the frame and up through the rubber membrane.
g) Clear.
5. Fold the power cord, and insert the power cord through the hole. -
Then push the power cord and the power plug through.
-
Press the drain hose through the rubber membrane.
-
Insert the hose holder, and firmly press the hoses and cord into the holder.
-
No other machine is connected to water. Place the seal on the holder.
-
Press together the “Click x 4” bushing with the hose holder. Slot (female) against the latch (male).
-
Press the Diaflex down into the hole.
-
Firmly screw (4 screws) until rubber swells 2mm outside the frame.
-
Tighten hose and cable. Remove the protective film on the tape. Attach the tape to the rubber and hose.
Tape around the hose. -
Press the tape down against the rubber.
Installation Collars
Installation Sealing Tape
| Art. nr. | RSK | Diaflex | Collars | Sealing Tape |
|---|---|---|---|---|
| 5902011-1 | 3839304 | x | x | x |
| 5902010-1 | 3839289 | x | x | |
| 590056 | 8039030 | x |
Approved by SP according to test Etz 5P08964-A Accepterad
monteringsanvisning 2021:1
https://tollco.se/vattensakert-kok-lackageskydd/slanggenomforing-diskmaskin/
TOLLCO AB
Rubanksgatan 4,
741 71 Knivsta. Sweden.
Tel +46 18 34 90 10.
info@tollco.se
tollco.se
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>