Watermark WM-BT27 Bluetooth Music Receiver User Guide
- June 5, 2024
- WaterMark
Table of Contents
**Watermark WM-BT27 Bluetooth Music Receiver User Guide
**
Quick Guide Bluetooth Music Receiver WM-BT27
Compatible with the following models:
- BMW: 1er (E81, E82, E87, E88), 3er (E90, E91, E92, E93), 5er (E60, E61), 6er (E63, E64), X5 (E70)
- Only in combination with
- CCC Radio-navigation system
Connect the adapter:
-
Remove the radio.
-
The plug of the Bluetooth adapter WM-BT27 must now be inserted from the back of the Quadlock plug into chamber C until it clicks into place. This should also work if the Quadlock plug is still on the radio. If the cables are too short or if you can’t see the rear of the plugs, you can disconnect the Quadlock plug completely from the radio beforehand.
-
Now connect the black ground cable of the WM-BT27 either to the radio housing or to the ground line leading to the radio. Without a good ground connection the function of the adapter is not given.
-
Now connect the red cable (ignition plus +12V) to a switched +12V line. As this is usually no longer available behind the radio, the voltage can be taken from the cigarette lighter or the air conditioner (measurement with multimeter necessary). Ignition on = +12V on / ignition off = 0V on.
-
Establish a Bluetooth connection by activating the Bluetooth search (pairing) and searching for the Bluetooth device “WM´´ . You should then set the volume on the connected device to full volume.
-
Before reinstalling the radio, test the function of the adapter. Switch on the AUX function with the Mode button or via the menu.
The AUX function must be enabled. If this is not the case, it must be enabled by a specialist workshop.
Anything unclear? You reach us MO-FR, from 8-17 o’clock under the E-Mail: service@watermark-germany.de
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>