WATERMARK TR24 Traditional Style Wall Mounted Pot Fillers Instruction Manual

: June 1, 2024
: WaterMark

Table of Contents

WATERMARK TR24 Traditional Style Wall Mounted Pot Fillers Instruction
IMPORTANT INFORMATION
PARTS BREAKDOWN
Prepare the mounting wall
Prepare the mounting bracket (1)
Prepare the mounting bracket (2)
Install the mounting bracket and pot filler
Secure the pot filler
Read More About This Manual & Download PDF:
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

WATERMARK TR24 Traditional Style Wall Mounted Pot Fillers Instruction

Manual

IMPORTANT INFORMATION

Thank you for choosing Watermark! We appreciate your commitment to Watermark quality products. Before you install the product, please fully review these installation instructions.
Before installation, unpack the product and inspect it for any damage. Make sure all the parts are present. If not installing immediately, place the product back into its pro- tective packaging.
The appearance of the product may be different than what is shown in this installation
manual, but the installation procedure will be the same.

Installation considerations:

Professional installation by a licensed plumber is strongly
Product should be installed according to local codes and
When installing:
Use Teflon tape or pipe sealant for threaded
DO NOT use plumber’s putty on any brass componants. This may cause thefinish to tarnish and void the warranty. Alkoxy silicone is recommended instead.
Flush the lines before and after installation (if applicable).
If the lines are sweated, do not overheat casting, which may damage
Copper adaptors may be required to complete

If you encounter any issues, please contact our technical support team at the number listed at the bottom of this page or email us at: technical@watermark- designs.com

PARTS BREAKDOWN

Prepare the mounting wall

Ensure that the supply nipple follows the diagram shown:
The 1/2-14” NPT supply nippleshould extend 1/2” from the wall.
The pot filler should only be used with cold water only to prevent hot water burns.

Prepare the mounting bracket (1)

Unscrew the set screws from the flange and mounting bracket.
Place the mounting bracket againstthe wall, then screw the pot filler onto the supply nipple

Prepare the mounting bracket (2)

Mark the screw hole positions onto the Then unthread the pot filler and remove the mounting bracket.
Drill 4x 3/8” pilot holes where marked in step 3A.
Apply several layers of teflon tape on the thread of the supply nipple.

Install the mounting bracket and pot filler

Insert 4x wall anchors into the pilotholes made in step 3B. B
Screw in 4x wood screws through the screw holes on the mounting bracket and into the wall anchors, securing the mount- ing bracket against the wall.
Insert the pot filler through the flangeand screw it onto the supply nipple. Tight-C en it until it is in the desired upright posi- tion.

Secure the pot filler

Thread the set screw onto the mount- ing bracket and tighten.
Slide the flange until it rests against the wall and covers the mounting bracket.
Thread the set screw onto the flange and tighten.