TRISTAR KA-5150 Fan Heater Instruction Manual
- June 3, 2024
- Tristar
Table of Contents
Instruction manual
KA-5150 Fan Heater
KA-5150
This product is only suitable for well insulated spaces or occasional use.
SAFETY
- By ignoring the safety instructions the manufacturer cannot be held responsible for the damage.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- Never move the appliance by pulling the cord and make sure the cord cannot become entangled.
- The appliance must be placed on a stable, level surface.
- The user must not leave the device unattended while it is connected to the supply.
- This appliance is only to be used for household purposes and only for the purpose, it is made for.
- This appliance shall not be used by children aged less than 8 years. This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Keep the appliance and its cord out of reach of children aged less than 8 years. Cleaning and user maintenance shall not be made by children unless older than 8 and supervised.
- To protect yourself against an electric shock, do not immerse the cord, plug, or appliance in water or any other liquid.
- WARNING: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
- Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate and clean the appliance or perform user maintenance.
- Children of less than 3 years should be kept away unless continuously supervised.
- Do not use the appliance with a programmer, timer, separate remote-control system or any other device that switches the heater on automatically, since a fire risk exists if the heater is covered or positioned incorrectly.
- Do not use this heater in the immediate surroundings of a bath, a shower or a swimming pool.
- Please do not install the appliance close to curtains and other combustible materials. This could cause a fire.
- The heater must not be located immediately below a socket outlet.
- The heater needs to be installed so that the switches and other controls cannot be touched by a person in the bath or shower.
- WARNING: In order to avoid overheating, do not cover the heater.
PARTS DESCRIPTION
- Power setting switch
- Power light
- Thermostat knob
- Handle
- Heating vent
- Air inlet
BEFORE THE FIRST USE
- Place the device on a flat stable surface and ensure a minimum of 10 cm. free space around the device. This device is not suitable for installation in a cabinet or for outside use.
- The unit can be placed vertically or horizontally on a flat stable surface.
- When the device is turned on for the first time, a slight odor will occur. This is normal, ensure adequate ventilation. This smell is only temporary and will soon fade.
USE
- Plug in the appliance to a grounded outlet.
- Put the power cable into the socket. (Note: Make sure the voltage which is indicated on the device matches the local voltage before connecting the device. Voltage 220V-240V ~ 50-60Hz).
- Turn the power setting knob to the desired setting.
Power setting knob
– FAN – for cool air
[ I ] – Low heating
[ II ] – High heating
-
Turn the thermostat control knob clockwise until it clicks, the power light
will illuminate and the heater will begin warming up. -
Turn the thermostat knob clockwise to increase the temperature or anti-clockwise to decrease the temperature.
-
When the desired room temperature has been reached, slowly turn the thermostat knob anti-clockwise to the minimal direction until the appliance switches off.
-
This set temperature will be automatically maintained.
-
When you have finished using your heater, turn the thermostat knob anticlockwise all the way to the lowest position
[ – ], turn the power setting switch off and unplug the unit.
AUTO SATETY SHUT OFF
- The heater has a built-in safety device, which will switch the heater OFF in case of accidental overheating. To reset the heater, follow the next steps:
- Turn the power settings knob to OFF .
- Unplug the heater and wait 5 -10 minutes for it to cool down.
- After the unit has cooled down, plug it in and operate it as normal.
- Never place objects on the heater, such as clothing or towels. Never use the heater in the bathroom or other wet areas. The air outlets of the heater can be very hot.
CLEANING AND MAINTENANCE
- Unplug the appliance and allow it to cool down. Use a soft, slightly damp cloth to wipe appliance surfaces. Do not allow water or any other liquid to get into the unit.
- Clean the air suction opening from time to time with a fine brush.
ENVIRONMENT
This appliance should not be put into the domestic garbage at the end of its
durability but must be offered at a central point for the recycling of
electric and electronic domestic appliances. This symbol on the appliance,
instruction manual, and packaging put your attention to this important issue.
The materials used in this appliance can be recycled. By recycling of used
domestic appliances, you contribute an important push to the protection of our
environment. Ask your local authorities for information regarding the point of
recollection.
Support
You can find all available information and spare parts at
www.tristar.eu!
[WEEE LOGO] **
WWW.TRISTAR.EU
Tristar Europe B.V. | Jules Verneweg 87
5015 BH Tilburg | The Netherlands**
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>