Tokyoflash R75 BINARY LED wrist WATCH User Manual
- June 5, 2024
- Tokyoflash
Table of Contents
Tokyoflash R75 BINARY LED wrist WATCH User Manual
Product Overview
Interpretation
Each watch mode is shown by the 4 Red Lights on the Upper Display. Hour Mode, Minute Mode, Binary Mode & Date Mode.
- Pressing the Mode button repeatedly will cycle through the modes. Hour Mode—Minute Mode—Binary Mode.
- Pressing the Set button enters Date Mode. (The watch will remember the last mode used & will always return to that mode the next time you use the watch, regardless of which button you press.)
Hour-centric Mode
The focus of this mode is on the hour with a rough representation of the
minutes.
So for example, at 10:48, the watch would round up to 10:50. Most useful for
general use when ‘about 1/2 past 3’ is good enough.
The Hour is shown in digits on the Lower Display. The Minutes are shown on the
Upper Display, where each light represents 5 minutes
Minute-centric Mode
The exact minute is displayed in digits. Most useful when you’re more concerned to know when it reaches exactly ’22 minutes past 7′ The Minutes are shown in digits on the Lower Display. The Hour is shown on the Upper Display, where each light represents 1 Hour.
Date Mode
Showing the month on the Upper Display (1-12) & the date on the Lower Display in digits.
Binary Mode
For the geek within. The time is displayed in binary on the Upper Display. The
top row of 6 lights show the Hour in Binary. The bottom rows of 6 lights show
the Minutes in Binary.
To read the time in Binary, refer to the example below. Binary numbers are
normally shown as zero’s & one’s, but on & off are also used.
Note: In Binary, the first number on the right is 1, then double it : 2, then double again: 4, then again: 8, 16, 32 etc Using the same method you can read Binary Numbers. The minutes ’22’ (as shown above) would be 10110 (where 1 is on & 0 is off)
Configuration
When setting the watch you will be asked to input, in this order: The Hour,
The Minute, The Month, The Date. At each step use the Mode button to change
the setting & the Set button to confirm & move to the next stage.
To begin setting the watch.
Press Mode to display the time & then hold the Set button for several seconds.
- Step 1) The Hour will flash on the Upper Display. Change & confirm the Hour as needed. (Mode button to change, Set to confirm) The Lower Display will show “A” or “P” to indicate AM/PM
- Step 2) The Minutes will flash on the Lower Display. Change & confirm the Minutes as needed. (Mode button to change, Set to confirm)
- Step 3) The Month will flash on the Upper Display and the Date LED will be lit. Change & confirm the Month as needed. (Mode button to change, Set to confirm)
- Step 4) The Date will flash on the Lower Display. Change & confirm the Date as needed. (Mode button to change, Set to confirm)
Enlightenment
3ATM Water Resistant.
This means the watch can resist splashes of water, but it should not get
excessively wet. Please do not use in the shower or for swimming.
1 x CR2025 lithium watch battery.
Life expectancy is calculated to last 1 year if the time is displayed, on
average, 12 times a day.
The warranty covers 1 year free from manufacturers defect. This does not include:
- Water damage.
- Broken Glass.
- Damage due to abuse or carelessness. For warranty issues, contact the store where you bought the watch.