Earda Technologies 10TBBVBA Smart Button Instruction Manual
- June 5, 2024
- Earda Technologies
Table of Contents
Earda Technologies 10TBBVBA Smart Button
Dimension
Specification
| Power supply: | Battery CR2032 3V DC |
|---|---|
| Communication: | ZigBee 3.0 Bluetooth Low Energy |
| Control distance: | 25m open area |
| Ingress Protection: | IP55 |
| Dimensions: | 45 X 45 X 12.5mm |
| Operating temperature: | -10 °C~45 °C |
| Working Humidity: | <90%RH |
| Life of battery | 1 years (General use) |
Install the battery / Reset / Pairing
-
Remove the screw
-
Install the CR2032 battery
-
Hold“RESET”to 6s, LED will start flashing
-
Install the cover
Connet to Network
Scan the QR code to download APP
Gateway is required to connect device
Add Device
Add Device
Remote mode (Default mode)
Remote mode
UI or functions may change according to firmware or APP version
B. Control description under remote mode
| Single Press On
---|---
| Dual Press Of
| Single Press Change preset light mode when light up
| Long Press >3s Dimming
Note: The above functions may be different depending on the model of the smart bulb
Mode swap
Scene mode
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC’s RF exposure guidelines, the distance must be at least 20 cm between the radiator and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>