Plastic Toys Factory S-011 RC Car User Manual
- June 5, 2024
- Plastic Toys Factory
Table of Contents
Plastic Toys Factory S-011 RC Car
WATCH REMOTE CONTROL INSTRUCTIONS
REMOTE CONTROL INSTRUCTIONS
HOW TO INSTALL THE BATTERY
Open the battery cover with a screwdriver, and install the corresponding battery according to the instructions
AUTOMATIC CODE INSTRUCTIONS
-
After put the batteries in the remote control, the indicate light flashing. and put the batteries in the car and set it on, starting to connect it, if successful,the controller indicates light off.
Note: otherwise repeat the above operation. -
Each remote control can only be connected with a remote control car, when the connection is Successtul, each car does not interfere with each other.
Note: not many cars connected at the same time. -
After one minute. The remote control did not find the 2.4g signal from the remote control vehicle, the power indicator Trashed, and the power switch should be restarted to frequency.
-
When you need to pair with other models with remote control or remote control car, you nred to turn offt the remote control and remote control car power can be repaired.
HOW TO CHARGE
- Before playing please charge the new battery pack.
- First, plug the battery pack plug in the charger, then plug the charger plugged in the socket.
- . The time required for the battery to be fully charged IS 0-150 minutes. The charging plug is equipped with in care there lidht0es out Do not overcharge. Charging for a long time will not increase the power.
- regularly check the toys and batteries, charging wire, and plugs, such as damaged parts should be discontinued until repaired or replaced before use.
PRECAUTIONS
Please don’t twist the wheels of the car with your bare hand’s car or car body to avoid damage to the car body gear structure.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>