Plastic Toys Factory ZSYJXD2020 REMOTE EXCAVATOR RC TRUCK User Manual
- June 5, 2024
- Plastic Toys Factory
Table of Contents
Plastic Toys Factory ZSYJXD2020 REMOTE EXCAVATOR RC TRUCK
INSTRUCTION MANUAL.
PLEASE READ THIS MANUAL CAREFULLY BEFORE USING IT.
PARTS LIST
SAFETY WARNING
TO PARENTS: TO ENSURE YOUR CHILD HAS A GOOD TIME AND SAFETY, EASE READ THIS MANUAL BEFORE USING IT. DON’ T PICK UP MOVING TOYS TO AVOID INJURY.
EXCAVATORS INTRODUCE
OPERATION OF REMOTE CONTROL INTRODUCTION
IMPORTANT BATTERY INFORMATION
BATTERY SAFETY TIPs
- Non-rechargeable batteries can not be charged;
- The power supply shall not be short-circuited
- The battery should be put in with the correct polarity
- Depleted batteries should be removed from the Toy;
- Different types of batteries or old and new batteries can not be mixed:
- It needs to be assembled by adults. Please make sure the power is off before installation;
- Waste batteries should be disposed of correctly as required by the environmental protection department;
- Please do not put the battery into the fire to avoid causing danger
- Do not wipe the surface of the toy with a damp cloth.
2. 4G FREQUENCY
After the excavator is properly loaded with batteries, turn on the power switch, and then properly load the remote control with batteries.At this point, the excavator and the remote control indicator light will flash several times to complete the frequency.
LOW BATTERY SIGNAL
If the excavator driving power is insufficient, the digging bucket is weak, lights dim or part of the function fails, there may be insufficient power, please turn off the power and replace the battery.
FREQUENTLY ASKED QUESTIONS
INSTALLATION INSTRUCTIONS FOR PAPERBOARD TRAY
INSTALLATION INSTRUCTIONS FOR THE CARDBOARD MODEL
SAND MOULD SCULPT
FCC STATEMENT
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference.
- this device must accept any interference received, including interference that may cause undesired operation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>