HILISIN BTWH00505201TXA012 Wireless Charger Cradle User Manual
- June 5, 2024
- HILISIN
Table of Contents
HILISIN BTWH00505201TXA012 Wireless Charger Cradle
wireless charger Cradle
- Model: BTWH00505201TXA012 Dimensions: 54.4 X 47.34mm
- Connector: USB TYPE-C
- Input: 5Vdc
- Output Frequency 205KHz
- Output: Support 0.5W maximum for Receiver
This is a magnetic wireless charger for smart watch. When the magnetic wireless charger is connected with 5V DC input, you can charge your device by simply placing your smart watch device on the charging area.
Warranty on safety
- Remove your charging device from any metallic cases before recharging.
- Do not place any aluminum or metallic products on the charging area.
- Do not place any plastic cards (credit card) or storage media (hard disk drive) containing magnetic strips on the
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate
this equipment. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 10cm between the radiator & your body.
CE:
During testing, BTWH00505201TXA012 are set to their highest transmission levels and placed in positions that simulate use against the head, with 10mm separation, and on the wrist, with no separation. When placing BTWH00505201TXA012 near your face, keep at least 10mm of separation to ensure exposure levels remain at or below the as-tested levels.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>