Shenzhen Xinglong New Plastic Products CHARTWS True Wireless Earbuds User Manual
- June 5, 2024
- Shenzhen Xinglong New Plastic Products
Table of Contents
Shenzhen Xinglong New Plastic Products CHARTWS True Wireless Earbuds
Charging
The case-charging LED indicator will flash RED while charging and will turn solid RED when fully charged. The earbuds will automatically begin charging when placed into the case. The earbuds’ LED indicators will turn RED while charging and turn BLUE while fully charged. (A tone will be heard when the earbuds are low battery, pls recharge when this happens)
Power On/Off
The earbuds will automatically power on when removed from the case, and power off when placed into the case. The earbuds will automatically pair to each other and then enter Bluetooth pairing mode. The earbuds can also be powered on and off by long pressing and holding the multi-function place. (The earbuds will automatically power off if they do not connect to a Bluetooth device after 2 minutes) Power the earbuds on, both of their LED indicators will flash RED and BLUE. After a moment,a voice will be heard on the earbuds indicating that they have paired to each other. The LED indicator on the main earbud will flash RED and BLUE, the auxiliary earbud’s LED indicator will be OFF.
Pairing
Select “TXCHARTWS” to pair. Once successfully paired to your device, a voice will be heard and the LED indicators on both earbuds will turn off.
Music playing and phone call
- press the touch area on either earbud to pause or resume playback / answer an incoming call / to end a phone call.
- press the touch area on either earbud to skip to the previous track.
- press the touch area on either earbud to skip to the next track. Long press + hold the touch area 2 seconds on either earbud to reject an incoming call.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. The product is too small to place complete label information, so the label is placed in the charging bin.