DEUTECMFG 49.924-F Wireless LED Trailer Light Magnetic Kit User Manual
- June 5, 2024
- DEUTECMFG
Table of Contents
DEUTECMFG 49.924-F Wireless LED Trailer Light Magnetic Kit
SPECIFICATION
Product Technical data
| Input Voltage | DC12V |
|---|---|
| Bluetooth module Version | 5.0 |
| Bluetooth Working Frequency | 2.4GHz |
| Battery Type & Qty | Lithium 21700# 4500mAh x2pcs totally |
| attery Charging time(Recommended) | 2Hour |
| Estimated working Time | 8 Hours |
| Actual Working Range (Recommended) | 0-25meter |
(depend on environment difference)
L ED Light Unit Quality Standard| DOT
Please noted:Recommended charging current is 2.0Amp/DC5V ( Y-type Charging cable can be used for Battery charging only ! )
Package Details
Button Operation/ Function
- L:Left R:Right
- Battery Capacity indicator
- Switch ON/OFF as press as 4-5second Meanwhile, short time press as 1 seconds or so will indicate battery carapacity available.
- Type-C Charging Port： Type-C
Using Instruction
Noted: First time using before, battery need full time charging (need 2h) Since Then , each time using before, need test battery capacity first, to ensure battery can work enough time
Step 1
Ensure receiver(Lights) magneted on rearside of trailer steel Frame.
Step 2
Transmitter Installation
Transmitter can plug-in towbar Socket on Vehicle end 
Step 3
Press receiver Box’s switch “ON”
rear light appearance as“Double Jump/Irregular flicked”.
Step 4
Wireless signals Matching & Locking
Turn On Vehicle engine and make Tail light On
during 5-8 seconds to carry out Signal matching and locking.
Step 5
Put F-Module into USB port on Driving room,
F-Module keep Green light-on as T/R connecting well When Alarm Buzzer sounds,
it means that signal connection failure happened between Transmitter and
Receiver
IMPORTANT NOTE
LED Light itself can pass DOT standard test
our product system apply to Emergency-towing mainly
Battery working time will be 8 hours, depend on difference driving ways &
environment conditions.
Maintenance
- Regular charging time and fully charging is necessary,
- check battery capacity indicator and check LED light each function work correct or not before using start.
- it is necessary to make 2hour charging if not use over 3 months, all Lithium battery have similar demand.
- stocking environment as dry is needed.
- When long time not use, its necessary to make battery charging during each 3 months
FCC Rules
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>