Shenzhen Ephan Technology CLWF Smart Down Light User Manual
- June 5, 2024
- Shenzhen Ephan Technology
Table of Contents
Shenzhen Ephan Technology CLWF Smart Down Light User Manual
Ephan Smart Down Lights included
Figure 1 .Smart canless recessed lights
Figure 2. smart can lights
Wall plate for smart down lights
No matter the wall plate is dimmable or not, there must be a button that can switch the lights on/off. If the wall plate is dimmable, please always set dimmer to maximum
Figure 3. dimmer with switch
Figure 4. dimmer without switch
Reason to use a dimmer with switch is that, in case require to reset the configuration of the lights, we need to switch the lights on-off for 5 times.
Configuration
Attention: Carefully follow the below guidance to finish the configuration before mount the WIFI lights up to the ceiling, try not to miss any step so that the configuration will be easy and quick.
- Down load and install the smart life App on cell phone from google play or apple store
Figure 5. Smart life app
-
prepare the name and password of the WLAN to be used for the WIFI lights on a memo paper, and enable blue tooth on cell phone.
-
prepare a cable with switch (available via your local dealer) , it is a very useful tool which can help user finish the configuration easily before mounting the lights onto the ceiling. It is recommended to finish the binding operation before mount the lights onto the ceiling.
-
Connect the lights to the special switch cable, or to any outlet with switch, switch on/off 5 times, then the lights will flash, that means it is waiting for connection to the smart life app. Click ‘Add Device’, wait for a short while, a message will pop up indicated app has founded this lights, click ‘ Go to add’, then input the WIFI name and password,
then wait for Smart life app to download control panel for this lights Till done.
Click the icon and title can then enter the control panel.
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment .
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>