LIEBHERR CS-1640B 30-Inch Stainless Steel Fridge-Freezer With NoFrost Instruction Manual
- June 5, 2024
- LIEBHERR
Table of Contents
- Please Read and Follow These Instructions
- Note to the Installer
- R600a Refrigerant
- Disposal of Old Appliance
- Electrical Safety
- Blocking for Safety
- Appliance Dimensions
- Cabinet Opening Dimensions
- Unit Venting
- Leveling the Appliance
- Mounting the anti-tipping device
- Changing Over Door Hinges
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
CS-1640B 30-Inch Stainless Steel Fridge-Freezer With NoFrost
Instruction Manual
Important
Please Read and Follow These Instructions
These instructions contain Danger, Warning, and Caution notes.
This information is important for safe and efficient installation and
operation.
Always read and comply with all Danger, Warning, and Caution notes!
DANGER!
Danger indicates a hazard that will cause serious injury or death if
precautions are not followed.
WARNING!
Warning indicates a potentially hazardous situation that, if not avoided,
could result in death or serious injury.
CAUTION!
Caution indicates a potentially hazardous situation that, if not avoided, may
result in minor or moderate injury.
IMPORTANT
This indicates information that is especially relevant to a problem-free
installation and operation.
Note to the Installer
It is very important to follow the instructions in the manual to ensure the
proper installation and operation of the unit.
Before installing the unit, be sure to thoroughly read and understand all of
the information in this manual.
WARNING!
Electrocution hazard.
Do not connect to the electrical outlet before the installation is completed.
R600a Refrigerant
WARNING!
The refrigerant contained within the appliance R600a is environmentally
friendly but flammable. Leaking refrigerant can ignite.
To prevent possible ignition follow the warnings below:
-
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.
-
Do not damage the refrigerant circuit.
-
Component parts and power cords shall be replaced with like components performed by factory authorized service personnel only.
Disposal of Old Appliance
DANGER!
Risk of child entrapment.
Child entrapment and suffocation are not problems of the past.
Junked or abandoned refrigerators are still dangerous –even if they will sit
for “just a few days.” If you are getting rid of your old refrigerator, please
follow these instructions to help prevent accidents.
Before you discard old appliances:
- Take off the doors.
- Leave the shelves in place so that children may not easily climb inside.
- Cut off the power cable from the discarded refrigerator. Discard separately from the refrigerator.
- Be sure to follow your local requirements for the disposal of appliances.
Contact the trash collection agency in your area for additional information.
WARNING!
Keep packaging materials away from children. Polythene sheets and bags can
cause suffocation!
Please recycle packaging material where facilities are available.
Electrical Safety
Connect this appliance to a 15 amp or 20 amp, 110120 VAC, a circuit that is
grounded and protected by a circuit breaker or fuse.
We recommend using a dedicated circuit for this appliance to prevent circuit
overload and the chance of interruption to the appliance.
This appliance is equipped with a three-prong (grounding) polarized plug for
your protection against possible shock hazards.
Where a two-prong wall receptacle is encountered, contact a qualified
electrician and have it replaced with a properly grounded three-prong
receptacle in accordance with all local codes and ordinances.
Disconnect power before installing the optional Side By Side Kit.
WARNING!
Electrocution hazard.
Electrical grounding is required.
-
Do not remove the round grounding prong from the plug.
-
Do not use extension cords or ungrounded (two prongs) adapters.
-
Do not use a power cord that is frayed or damaged.
-
Do not use a power strip.
Failure to follow these instructions may result in fire, electrical shock, or death.
Blocking for Safety
WARNING!
To avoid a hazard due to the instability of the appliance, it must be fixed in
accordance with the instructions.
Appliance Dimensions
Cabinet Opening Dimensions
The appliance can be used freestanding or semi-built-in.
If semi-built-in, please consider the cabinet opening dimensions
IMPORTANT
The power plug must be easily accessible so that the appliance can be
disconnected from the mains quickly in an emergency. It must not be behind the
back of the appliance.
Clearance on the back must be 2 inches (51 mm).
NOTE
If the gap between the rear of the appliance and the wall is less than 2
inches (51 mm), the power consumption level may increase
Unit Venting
Do not restrict the airflow.
The ventilation opening can either be directly over appliance 1, above the
cabinet, and below the ceiling 2 or through a vent installed in a soffit 3.
IMPORTANT
The clear ventilation cross-section must be at least 31 in² (200 cm²) from the
lower ventilation opening right to the upper one.
The section below the freezer door and the floor
must not be covered.
Leveling the Appliance
IMPORTANT
After final installation, this screw must be turned down until it has proper
floor contact to support the hinge bracket.
CAUTION
Risk of injury or damage from the appliance tipping or the door falling open!
If the additional adjustable foot on the base support is not correctly
positioned on the floor, there is a risk of the door falling open or the
appliance tipping. This can lead to injury or property damage.
▶Unscrew the additional adjustable foot on the support until it reaches the
floor.
▶Then turn it another 90°.
Mounting the anti-tipping device
WARNING!
Tip over hazard!
The anti-tipping brackets must be mounted to prevent the appliance from
tipping when the fully stocked door is opened.
IMPORTANT
Be sure that there is no plumbing or electrical wiring located in this area
which screws or drills could damage.
- Mark the center of the appliance on the back wall.
- Mount the anti-tipping brackets within the given area.
IMPORTANT
The screws for fastening the anti-tip device are not supplied with the
appliance. Appropriate screws must be used for the material (wood, concrete,
etc.) in which the safety device is mounted.
Changing Over Door Hinges
Door hinges should only be changed by a trained expert.
Changing over the door hinges requires two people.
IMPORTANT
The door must now be held secure by another person.
IMPORTANT
The door must now be held secure by another person.
|
---|---
|
For Service in the U.S.
Liebherr Service Center
Toll Free: 1-866-LIEBHER or
1-866-543-2437
Email: Service-appliances.us@liebherr.com
PlusOne Solutions, Inc.
3501 Quadrangle Blvd, Suite 120
Orlando, FL 32817
For Service in Canada
Liebherr Service Center
Toll Free: 1-888-LIEBHER or
1-888-543-2437
www.euro-parts.ca
EURO-PARTS CANADA
39822 Belgrave Road
Belgrave, Ontario, N0G 1E0
Phone: 519-357-3320
Fax: 519-357-1326www.liebherr-
appliances.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>