metos MG105 Ice Storage Bin Installation Guide
- June 5, 2024
- metos
Table of Contents
metos MG105 Ice Storage Bin Installation Guide
Introduction
The ICEMATIC ice containers are constructed according to the same rigorous
technical specifications as adopted for the ice makers.
By combining perfectly with the respective modular units, they provide a wide
range of combinations for meeting the most varied requirements.
The basic concepts that inspired Frimont in the design and production of the
current range of ice containers were: compact dimensions, in terms of both
height and footprint, easy pickup of the ice, possibility of increasing the
effective volume, duration and variety of storage capacity.
CONSIDERATIONS REGARDING THE INSTALLATION AND LOCATION OF THE CONTAINER
Place of installation
On the modular ice makers the ice container also serves as a support base for
the production unit. When selecting the place of installation, it is therefore
necessary to follow the instructions and advice given in the user instruction
handbook.
Installation of the container
Check the outer packing to make certain that it has not been damaged in
transit. After removing the box, inspect the container thoroughly both inside
and out to make sure it has not been damaged during transport, loading or
unloading.
Lie the container on its back, easing it onto the box it was packed in, in
order to fit the four feet into their seats.
Stand the container up again, then position it in the installation site,
making sure that the floor is even and capable of supporting the weight of the
unit.
Level the ice container in both directions, from right to left and from front
to back.
Check that the foam-rubber seal round the top edge of the container is in
perfect condition; replace if necessary with food-grade sealant.
Water drainage connection
IThe drainage fitting, with an external diameter of 18 mm, is always located
at the bottom or bottom back of the container, and must be connected, by means
of a ventilated pipeline at a constant gradient, to an open-trap waste outlet.
Important
Before positioning the ice maker on the container, wash the inside of it with
soap and water or with a handful of sodium bicarbonate diluted in two litres
of warm water; then rinse and dry thoroughly.
DAILY PRECAUTIONS
- DO NOT stow bottles or other items such as milk, butter,fruit juice, etc. in the ice container.
- NEVER leave the door open.
- DO NOT leave the ice shovel in the container
- Open and close the door gently, taking care not to slam it.
CLEANING AND MAINTENANCE
The inside of the container is in contact with ice, which is a food product.
It is therefore imperative that it is cleaned regularly and thoroughly.
Once a week it is essential to wash the inner walls of the container, having
first removed the ice from it, using soap and water or a handful of sodium
bicarbonate diluted in two litres of warm water; then rinse with running water
and disinfect with specific products; lastly, dry thoroughly.
Installation diagram
Removing the bin door
Dimensions
MG105
MG155
MG205
MG255
MG305
MG405
MG505
Disposal of waste electronic and electrical equipment (WEEE)
Fulfilling Directives 2002/95/CE, 2002/96/CE and 2003/108/CE on the disposal
of waste electronic and electrical equipment.
The crossed out wheeled bin symbol indicates the product must be collected
separately from other waste when it has become redundant. Differentiated
collection of this equipment is arranged and handled by themanufacturer.
Consequently, the user who is wanting to dispose of this equipment must
contact the manufacturer and follow the method the latter has adopted to allow
separate collection of the redundant equipment.
Appropriate differentiated collection for the subsequent recycling, treatment
and eco-friendly disposal of the dismantled equipment prevents possible
negative effects on the environment and health and facilitates the recycling
of materials used in manufacturing the equipment.
Administrative sanctions foreseen by the regulations in force shall be applied
for any abusive disposal of the product by the holder.
