Shenzhen Tecson Trade Technology H-J10 Wireless Microphone User Manual

Shenzhen Tecson Trade Technology H-J10 Wireless Microphone

Introduction

Thanks for choosing our product. This product is a smart wireless microphone that provides professional-grade recording output. Plug and play, no app required. Multiple uses: It can be used in online live broadcast video Vlog shooting, program interviews, recording, video teaching and otherOCcasions. The wireless Microphone consists of two parts, one is Microphone. Transmitter, the other one is the receiver (See as below picture) *Some mobile phone apps do not support external microphones, which will cause silent recording. In this case, please replace the app and continue to use the product.

ID DIAGRAM

1.  Windproof net
2. Microphone indicator
3. Charge&monitor headphone jack
4. Microphone clip
5. Switch key
6.  Type-C port to connect phone
7. Receiver indicator
8.  Type-C port of receiver
9. Charging box Type-c charging port
10. 1 Charging box indicator light

HOW TO  USE

• Step 1: Connect the receiver to the phone intertace
• Step 2: Press the  switch key of microphone 2s, the indicator light turns blue, and then power IS turned on,
• Step 3: After successful automatic pairing, the red light at the receiving end is always on and the blue light at the transmitting end is always on. Then open the phone camera.live App or other Apps,and then to use the microphone to receive sound.

ABOUT UI

Microphone Transmitter

Noise reduction

mode

| Briellypressthepowerkeyinthe connected state

( noise reduction by default)

| Blue light /Green light
Low battery alarm| Battery is below 20%| Red light flashes slowly
Reset| Press and hold the power key|
monitor| Plug the matching headset into the monitoring port

Receiver

Packing List

Content of packing

1.  Microphone transmitter
2.  Receiver
3.  Monitor earphone
4.  User manual
5.  Storage box
6. Charging line

FCC RULES

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

•  this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•  Consult the dealer or an experienced radio/TV technician for help.

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>