Eway Tradings 2AXIO-SWRC1 SWRC1 METAL ASSEMBLED TOYS User Manual
- June 5, 2024
- Eway Tradings
Table of Contents
Tradings 2AXIO-SWRC1 SWRC1
METAL ASSEMBLED TOYS
User Manual
| Back of receiving box | Receiver front |
|---|
| 
2AXIO-SWRC1 SWRC1 METAL ASSEMBLED TOYS
Master switch: shift to open gear to adjust the frequency
Switch: Click On, click Off
A key 1: corresponds to A motor socket, and the motor is in forwarding
rotation.
F key 1: corresponding to A motor socket, the motor is in forwarding
rotation.
Key 2: Corresponding to A motor socket, motor reversal.
F key 2: corresponding to A motor socket, motor reversal.
Key. 1: Corresponding to A motor socket, the motor is turning forward.
G key 1: corresponding to A motor socket, motor forward
Button 2: corresponding to A motor socket, motor reversal.
G key 2: corresponding to A motor socket, motor reversal.
Key 1: Corresponding to A motor socket, the motor is turning forward.
H key 1: corresponding to A motor socket, the motor is in forwarding
rotation.
Key 2: Corresponding to A motor socket, motor reversal.
H key 2: corresponding to A motor socket, motor reversal.
Key 1: Corresponding to A motor socket, the motor is turning forward.
I key 1: corresponds to A motor socket, motor forward
Button 2: corresponds to A motor socket, motor reverse.
Key 2 of I: corresponds to A motor socket, and key 1 of motor reversal:
corresponds to A motor socket, and the motor is in forwarding rotation.
J key 1: corresponding to A motor socket, motor forward
Button 2: corresponding to A motor socket, motor reversal.
J key 2: corresponding to A motor socket, motor reversal
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
