LENSGO L322 Portable Cell Phone Tripod Tabletop Stand Instructions
- June 5, 2024
- LENSGO
Table of Contents
L322 Portable Cell Phone Tripod Tabletop
Stand Instructions
L322 Portable Cell Phone Tripod Tabletop Stand
How to Replace Battery:
use a tool such as a screw:Inver or coin to pry open cover lid. Insert
CR1632 battery with positive(-) side facing up.
How to use Remote:
- Photo/Video: Click to take a photo. Click to record video/ Click again to stop recording
- Power ON/OFF: Press and hold (3 sec) to power ON. Press and hold (3 sec) to ( power OFF.
NOTE: Once paired to the smartphone you no longer need to pair it again. Simply hold down the shutter button on the remote(3 sec) until the blinking light appears to connect. Hold down the shutter button again until the blinking light appears to disconnect.
STEP 1: Remove the Wireless Remote Shutter by pushing out from the back side of the leg. Connect via Bluetooth® on your phone’s settings. Pairing the Wireless Remote Shutter to your phone:
- Go to your phone’s settings and turn Bluetooth on
- Press and hold the remote button(3 seconds) until a blinking Blue light appears
- The blinking Blue light indicates it is pairing with your smartphone
- On your phone you will see the “Bower” name, select it to pair
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user, s authority to
operate the equipment.
NOTE: This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>