Harman LIVEPROTWSP My JBL Headphones User Guide
- June 5, 2024
- Harman
Table of Contents
- Harman LIVEPROTWSP My JBL Headphones
- WHAT’S IN THE BOX
- APP
- how to wear
- First time use
- power on & CONNECT
- DUAL CONNECT + SYNC
- power off
- MANUAL CONTROLS
- BUTTON COMMAND
- Auto Play/Pause
- DO MORE WITH THE APP
- Charging
- led behaviors
- TECH SPEC
- IC RF Exposure Information and Statement
- IMPORTANT SAFETY INSTRUCTIONS
- Federal Communication Commission Interference Statement
- WEEENotice
- For Products That Include Batteries
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Harman LIVEPROTWSP My JBL Headphones
WHAT’S IN THE BOX
APP
how to wear
First time use
power on & CONNECT
- Google Assistant will be integrated later Over-The-Air (OTA) automatically
DUAL CONNECT + SYNC
power off
MANUAL CONTROLS
BUTTON COMMAND
Auto Play/Pause
DO MORE WITH THE APP
Charging
led behaviors
TECH SPEC
- Model: LIVE PRO+ TWS
- Driver Size: 11 mm/0.43” Dynamic Driver
- Power supply: 5 V 1 A
- Earpiece: 6.95 g per pc (13.9 g combined) / 0.015 lbs per pc (0.03 lbs combined)
- Charging case: 54.7 g/0.12 lbs
- Headset battery type: Lithium-ion polymer (3.7 V, 55 mAh)
- Charging case battery type: Lithium-ion polymer (3.7 V, 500 mAh)
- Charging time: 2 hrs from empty
- Wireless Charging time: 3 hrs from empty
- Music playtime with BT on and ANC on: up to 5.5 hrs
- Music playtime with BT on and ANC off: up to 7 hrs
- Frequency Response: 20 Hz – 20 kHz
- Impedance: 16 ohm
- Sensitivity: 102 dB SPL@1kHz/1mW
- Maximum SPL: 91 dB
- Microphone sensitivity: -38 dBV@1kHz/Pa
- Bluetooth version: 5.0
- Bluetooth profile version: A2DP V1.3, AVRCP V1.6, HFP V1.7
- Bluetooth transmitter frequency range: 2400 – 2483.5 MHz
- Bluetooth transmitter power: <13 dBm (EIRP)
- Bluetooth transmitter modulation: GFSK, π/4 DQPSK, 8DPSK
- Maximum operation temperature: 45°C
IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaged over one gram of tissue.
Device types: (IC: 6132A-LIVEPROTWSP) has also been tested against this SAR
limit According to this standard, the highest SAR value reported during
product certification for head use is 0.7975 W / kg. The device was tested for
typical bodily operations where the product was kept 0 mm from the head. To
maintain compliance with IC RF exposure requirements, use accessories that
maintain a separation distance of 0mm between the user’s head and the back of
the headset. The use of belt clips, holsters and similar accessories shall not
contain metal parts in its assembly. Use of accessories that do not meet these
requirements may not comply with IC RF exposure requirements and should be
avoided.
Head operation
The device was subjected to a typical head manipulation test. In order to
comply with RF exposure requirements, a minimum separation distance of 0 cm
must be maintained between the user’s ear and the product (including the
antenna). Head exposure that do not meet these requirements may not meet RF
exposure requirements and should be avoided. Use only the supplied or approved
antenna.
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
IMPORTANT SAFETY INSTRUCTIONS
For all products:
- Read these instructions.
- Keep these instructions.
- Heed all warnings.
- Follow all instructions.
- Do not block any ventilation openings. Install this apparatus in accordance with the manufacturer’s instructions.
- Do not install this apparatus near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
- Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles and the point where they exit from the apparatus.
- Use only attachments/accessortes specified by the manufacturer.
- Use only with the cart, stand, tripod, bracket or table specified by the manufacturer or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
- Unplug this apparatus during lightning stonns or when unused for long periods of time.
- To disconnect this apparatus from the AC mains completely, disconnect the powersupply cord plug from the AC receptacle.
- The mains plug of the power-supply cord shall remain readily operable.
- Do not expose batteries to excessive heat such as sunshine, fire or the like.
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
THE LIGHTNING FLASH WITH AN ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERTTHE USER TO THE PRESENCE OF UNINSULATED”DANGEROUS
VOLTAGE”WITHIN THE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDETO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO PERSONS.
THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERTTHE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS INTHE LITERATURE ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
CAUTION FCC AND IC STATEMENT FOR USERS (USA AND CANADA ONLY)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two condttions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. CAN
ICES-3(8)/NMB–3(8)
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limtts are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to tiy to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circutt different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by HARMAN could void
the users authority to operate the equipment
For Products That Transmit RF Energy:
FCC ANO IC INFORMATION FOR USERS
This device complies with Part 15 of the FCC rules and Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two
conditions:
- This device may not cause harmful interference; and
- this device must accept any interference received, including interference that may cause undesired operation.
Note to CATV System Installer:
This reminder is provided to call the CATV (cable TV) system installe(s
attention to article 820-40 of the NEC, which provides guidelines for proper
grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as close to the point of
cable entry as possible.
For CD/DVD/Blu-ray Disc Players:
Caution:
This product uses a laser system. To prevent direct exposure to the laser
beam, do not open
the cabinet enclosure or defeat any of the safety mechanisms provided for your
protection. DO NOT STARE INTO THE LASER BEAM. To ensure proper use of this
product, please read the owne(s manual carefully and retain tt for future use.
Should the unit require maintenance or repair, please contact your local JBL
service center. Refer servicing to qualified personnel only.
FOR ALL EU COUNTRIES:
For products that indude audio out Prevention of hearing loss
Caution: Permanent hearing loss may occur if earphones or headphones are used
at high volume for prolonged periods of time.
For France, the products have been tested to comply wtth the Sound Pressure
level requirement laid down in the applicable NF EN 50332-1 :2013 and/or EN
50332-2:2013 standards as required by French Article l.5232-1.
Note: To prevent possible hearing damage, do not listen at high volume levels
for long periods.
WEEENotice
The Directive on Waste Electrical and Electronic Equipment (WEEE), which
entered into force as European law on 14/02/2014, resulted in a majorchange in
the treatment of electrical equipment at end-of-life.
The purpose of this Directive is, as a first priority, the prevention ofWEEE,
and in addition, to promote the reuse, recycling and other forms of recovery
of such wastes so as to reduce disposal. The WEEE logo on the product or on
its box indicating collection for electrical and electronic equipment consists
of the crossed-out wheeled bin, as shown below.
This product must not be disposed of or dumped with your other household waste. You are liable to dispose of all your electronic or electrical waste equipment by relocating over to the specified collection point for recycling of such hazardous waste. Isolated collection and proper recovery of your electronic and electrical waste equipment at the time of disposal will allow us to help conserving natural resources. Moreover, proper recycling of the electronic and electrical waste equipment will ensure safety of human health and environment. for more information about electronic and electrical waste equipment disposal, recovery, and collection points, please contact your local city center, household waste disposal service, shop fiom where you purchased the equip men or manufacturer of the equipment.
RoHS Compliance
This product is in compliance with Directive 2011/65/EU of the European
Parliament and of the Council of 8 June 2011 on the restriction of the use of
certain hazardous substances in electrical and electronic equipment.
For Products That Include Batteries
EU Batteries Directive 2013/56/EU
A new battery directive 2013/56/EUon Battery and Accumulator replacing
directive entered into force on the 01/07/2015. The directive applies to all
types of batteries and accumulators
(AA, AAA, button cells, lead acid, rechargeable packs) including those
incorporated into appliances except for military, medical and power tool
applications. The directive sets out rules for collection, treatment,
recycling and disposal of batteries, and aims to prohibtt certain hazardous
substances and to improve environmental performance of batteries and all
operators in the supply chain.
lnsturctions for Users on Removal, Recycling and Disposal of Used
Batteries
To remove the batteries fiom your equipment or remote control, reverse the
procedure described in the owner’s manual for inserting batteries. for
products with a built-in battery that lasts for the lifetime of the product
removal may not be possible for the user. In this case, recycling or recovery
centers handle the dismantling of the product and the removal of the battery.
If, for any reason, it becomes necessary to replace such a battery, this
procedure must be performed by authorized service centers. In the European
Union and other locations, tt is illegal to dispose of any battery with
household trash. All batteries must be disposed of in an environmentally sound
manner. Contact your local waste-management officials for information
regarding the environmentally sound collection, recycling and disposal of used
batteries.
WARNING: Danger of explosion if battery is incorrectly replaced. To reduce
risk of fire or burns, don’t disassemble, crush, puncture, short external
contacts, expose to temperature above 60’C (140°F), or dispose of in fire or
water. Replace only with specified batteries. The symbol indicating ‘separate
collection’for all batteries and accumulators shall be the crossed-out wheeled
bin shown below:
In case of batteries, accumulators and button cells containing more than 0.0005 % mercury, more than 0.001 % cadmium or more than 0.004 % lead, shall be marked wtth the chemical symbol for the metal concerned: Hg, Cd or Pb respectively. Please Refer to the below symbol:
WARNING
DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD [The remote control supplied with]
This product contains a coin/button cell battery. If the coin/button cell
battery is swallowed, tt can cause severe internal burns in just 1 hours and
can lead to death. Keep new and used batteries away from children. If the
battery compartment does not close securely, stop using the product and keep
it away from children. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
For All Products Except Those with Wireless Operation:
HARMAN International hereby declares that this equipment is in compliance wtth
the EMC 1014/30/EU Directive, LVD 1014/35/EU Directive, ErP 1011/17 /EU
Directive and RoHS 1011/65/ EU Directive. The declaration of conformity may be
consulted in the support section of our Web site, accessible from
www.jbl.com.
For All Products with Wireless Operation:
HARMAN International hereby declares that this equipment is in compliance wtth
the essential requirements and other relevant provisions of Directive
1014/53/EU, ErP 2011/27 /EU Directive and RoHS 1011/65/EU Directive The
declaration of conformity may be consulted in the support section of our Web
site, accessible from www.jbl.com.
HARMAN
HARMAN International Industries, Incorporated
8500 Balboa Boulevard, Northridge, CA 91329 USA
516.255.4545 (USA only)
HARMAN International Industries, Incorporated. All rights reserved. JBL is a
trademark
of HARMAN International Industries, Incorporated, registered in the United
States and/or other countries. Features, specifications and app,arance are
subject to chang, without notice.