Shenzhen HPS0600 LED Karaoke Speaker User Manual

Shenzhen HPS0600 LED Karaoke Speaker User Manual

Buttons Operation

1. M/POWER Hold(Power):Press(Mode):Mode switching;

2. MIC VOL
   +:The microphone volume increase.
   – :The microphone volume decrease;

3. REMIX VOL
   +:The reverberation volume increase.
   -:The reverberation volume decrease;

4. Shore press for next song,long for the volume increase;

5. Play/pause,Under FM steate, hole it for automatic search;

6. Shore press for prey song,long for the volume decrease;

7. LED
   Long press:LED switch; Short press:microphone switch; USB:MP3 song

8. playing with USB port;

9. TF: TF socket MP3 song playing;

10. DC 5V/ ANT
    DC 5V:Power slot;
    ANT:FM mode need to insert to insert audio line ACTS as a radio antenna;

11. The headset

Wireless Karaoke

1. Supply power: Hold M/POWER button to start the product.
2. Wireless connection: enable the wireless of mobile phone, click to connect, successful connection if prompt tone is produced.
3. Adjust sound: adjust the sound volume of mike and the reverberation to suitable level.
4. Start Karaoke

Technical Parameters

• Output Power: 5W
• Frequency Range: 100HZ-10KHZ
• Max Sound Pressure Level: >115DB 1KHZ TDH < 1%
• Reverberation Mode: sound effect reverberation
• Power Supply: Built-in 18650 Li-battery
• Battery Capacity: 800mAh
• Charging Power: DC5V

FCC statement

FCC ID: 2AM8S-HPS0600

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

FCC Radiation Exposure Statement
This device complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>