Recoil BRC-1 Waterproof Remote Control Instructions

June 5, 2024
RECOIL

Instructions

  1. Double click the pairing ” ‘ button to pair the wireless remote with Soundbar
  2. Press ” + ” & ” – ” for level up & down
  3. Press ” “&” “for track forward & backward
  4. Press ” ” to play and pause music Press and hold ” ” to power on/off the soundbar
  5. Double tap “ ” to switch between Bluetooth and Aux modes
  6. LED low battery indicator (Green), operation indicator (Blue) & charging indicator (Red)

Recoil BRC 1 Waterproof Remote Control-

BATTERY CHARGING

Open the cover at the back of the unit, you will see the micro USB charging port. Plug in any DC5V/2.1A micro USB cable to charge the battery, and the red LED stays on. When it is fully charged, the red LED stays off.

STEERING WHEEL/BAR MOUNT
Snap the unit into the plastic adaptor. Using the included rubber band for the steering wheel & bar mounting, hold the rubber against the steering wheel. Wrap it around, then hook it up.

Recoil BRC 1 Waterproof Remote Control-fig2

NOTE: You can also just simply “Velcro” the remote to the dash of your UTV or Golfcart

SLING

Use the included sling to carry this waterproof remote control.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.

Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals