Govee H6193 LED Lights Kit User Manual

: June 5, 2024
: Govee

Table of Contents

Govee H6193 LED Lights Kit
At a Glance
Specifications
Installing Your Strip Light
FCC Statement
Customer Service
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Govee H6193 LED Lights Kit

Govee-H6193-LED-Lights-Kit-product

At a Glance

LED Strip Light	8
Remote Controller
Cable Ties	20
User Manual

Specifications

Length	2x10cm + 4x20cm + 2x30cm I 2×0.328ft + 4×0.656ft + 2×0.984ft
Lighting Color	RGB
Voltage	12V
Control Way	Remote control
Waterproof	Light strip: IP67 Control Box: Only Splash-proof

Installing Your Strip Light

Preparation Before Installing
Unpack the box and check whether all items are intact;
Power on the strip light to check whether it works well;
Connect the DC wires to the power brick;
Fix the DC wires on the engine compartment near the battery;
( Notice : Do not fix on the part that easily gets hot.)
Wire the power line of light to motorcycle battery. Red for positive, Black for negative, Blue for brake.
Installing Steps:
Wipe off the installing surface. Make sure it’s clean, dry and smooth;
Remove the protective film from the adhesive tape and stick the strip light;
( Notice : Do not move the strip light to other places once attaching.)
Remove air bubbles between the strip and surface by pressing the strip from end to end, and fix the fastener by screws to the strip;
Power on the strip and start to use.
Using the Strip Light with RF Remote

A

| Short press: Switch color cyclically. First eighteen are preset colors. Nineteenth is 7 colors jumping and twentieth is 7 colors fading.

Long press: Adjust light brightness cyclically. 5 level in total.

---|---
B| Short press: Make current preset color to jump or fade.

Long press: Adjust the speed of jumping/fading mode.

C| Short press: First, make current preset color to enter music mode. Second,

make 7 colors to enter music mode.

D| Short press: Turn on/off led strip light.

FCC Statement

This device complies with Part 15 of the FCC Rules . Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Non-replaceable light source. Not intended for illumination. Only used for creating ambiance.

Do not connect the rope light to the supply while it is in the packing or wound onto a reel;
Do not use the rope light when covered or recessed into a surface;
Do not open or cut the rope light;

CAUTION:
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS. Govee is a trademark of Shenzhen lntellirocks Tech Co.,Ltd. Copyright ©2021 Shenzhen lntellirocks Tech Co.,Ltd. All Rights

Responsible party: