Shenzhen 2AXKH-AX200 WI-FI Card band wireless User Manual

Shenzhen 2AXKH-AX200 WI-FI Card band wireless

This driver is suitable for: AX200，AX200Pro, WIE9260, WIE8260, WIE7265, AX200NGW,AX200S
Release Date: May 20, 2020
Driver support: Win10 64 bit
Note: Since this product is a high-performance AC wireless network card, the minimum requirement is WIN10 64-bit system and does not support 32-bit! Please select the corresponding driver installation according to your product model and system

Hardware installation

1. Unscrew the screws of the chassis and push it out to remove the side cover
   

2. Remove the file corresponding to the PCI-E interface ( supports graphics card installation )
   More file removal tutorials

3. Insert the four-wire connector of the Bluetooth cable into the wireless network card

4. Align the NIC card with the gap between the chassis and the motherboard and insert it to the end

5. Insert the other end of the Bluetooth cable into the 9-pin USB port on the  motherboard

6. Tighten the screws, fix the network card and install the antenna

Driver Installation

1. Check if the device manager detects the card  ( My Computer-Right Click-Management-Device Manager ) 

2. Run the driver ” WIFI_21.0.0_Driver64 ” to install

3. Check whether the driver is installed normally ( My Computer-Right Click -Management-Device Manager ) 

4. selection signal WIFI password connected to

5. 5 Run ” Win10_64 ” Bluetooth driver and select ” Next ”

6. Choose the type ” typical ” to install next
   

7. Check “I accept the terms (A) in the license agreement” as shown in the figure and select the next step

8. complete as shown

9. Start Menu-Settings-Devices – Add Bluetooth or other devices

10. add a device type, as

11. selected Bluetooth device connection ( Bluetooth devices need to deploy pairing mode ) 

12. The connection is completed as shown

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>