LIDIAN CP-ZJ02 360 Object Tracking Holder User Manual
- June 5, 2024
- LIDIAN
Table of Contents
LIDIAN CP-ZJ02 360 Object Tracking Holder
Install the battery
Open the battery cover, install three No. 5 alkaline dry batteries according to the direction marked on the battery box, and then screw off the battery cover.
Install mobile phone
Open the mobile phone clip, slide the mobile phone into the mobile phone clip according to the direction of the mobile phone lens in front, so that the mobile phone can be adjusted properly.
Horizontal and vertical switching
Turn off the knob, release the phone clip and turn it into horizontal/vertical screen mode. After tightening the knob, install the mobile phone.
Power on
Press the key to start the machine, and the red light flashes: long press to turn off the machine, and the red light goes out.
Connecting devices
- PTZ starts, red light flashes, PTZ is in the state of waiting for Bluetooth connection
- Turn on the Bluetooth and location information (GPS, positioning) of the mobile phone, open the app, do not need to pair the mobile phone Bluetooth, wait for 3-6 seconds, the PTZ and app will automatically connect
- When the PTZ blue light flashes, the Bluetooth icon on the app interface turns blue, and the PTZ and app are automatically connected
- 40 seconds automatic shutdown without Bluetooth
Enter the app and the blue light will flash after the automatic connection is successful, You can start 360 ° intelligent shooting
OVERVIEW
Special tips:
- During the connection process between PTZ and mobile phone, there is no need to search for Bluetooth name and manually pair Bluetooth.
- Some mobile phone models may have Bluetooth link delays. Please wait patiently for Bluetooth automatic connection to succeed, or restart PTZ and app and continue to try automatic connection
- it can follow the movement of the face and follow the camera.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Information
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.