Hong Chuang Shen Zi HX399 Wireless Charger User Guide

June 5, 2024
Hong Chuang Shen Zi

Zi HX399
Wireless Charger
User Guide

Product Overview

Hong Chuang Shen Zi HX399 Product Overview

Specifications

Name wireless charger
Model HX399,HX399-P
Material Environmental protection ABS + tempered glass
Size 204X80X7.8MM
Colour Black
Interface Type-C USB
Input Current ≥9V-2A, 5V-3A
Phone output 15W/10W/7.5W/5W
Watch output 2.5W
Headphone output  3W
Adapter ≥9V-2A, 5V-3A
Compatibility Supports mobile phones, Bluetooth headsets,
and Apple Watches that meet the Qi standard
Product List Wireless charger xl, charging cable xl, manual xl

III. The use steps

Insert the USB charging cable to the power adapter and connect the charger with the USB cable, then the device is connected to the power supply and starts to work in a powered state.

  • When charging the mobile phone, place the mobile phone in the charging area of the mobile phone, and after 0.1 seconds, start charging the mobile phone; When fully charged, just remove the phone; during the charging process, if you need to terminate the charging, directly Just take off the phone.
  • When charging the Apple Watch, place the watch flat on the watch charging area, and after 0.1 seconds, start charging the watch; When fully charged, just remove the phone; if you need to terminate the charge during the charging process, just remove the watch.
  • When charging the Bluetooth headset, place the headset flat on the headset charging area, and after 0.1 seconds, start charging the headset; When fully charged, just take off the headset; during the charging process, if you need to terminate the charging, take just drop the headset.
    IV.Warranty instructions If there is no obvious appearance of material damage under normal use, the warranty shall be calculated for 18 months from the day of

FCC regulatory conformance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals