digipower TP-RGH10 Go Viral Smartphone Video Grip User Guide
- June 5, 2024
- digipower
Table of Contents
- digipower TP-RGH10 Go Viral Smartphone Video Grip
- Product Diagram
- Bluetooth pairing
- Inserting the mobile phone into the holder
- Taking photos/recording video
- Mounting to a tripod and taking pictures remotely
- Replacing the battery on the remote control
- Operational notes
- WARRANTY INFORMATION FOR DIGIPOWER PRODUCTS, A DIVISION OF MIZCO
- FCC STATEMENT :
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
digipower TP-RGH10 Go Viral Smartphone Video Grip
Product Diagram
- Photo button
- Indicator light for remote control
- Handle
- Adjustable arm for mobile phones
- 1/4″ standard tripod screw thread
Bluetooth pairing
Press the photo key for 3 seconds to enter the Bluetooth pairing state; the
green light on the remote will blink rapidly when it is in pairing mode.
Open your mobile phone’s settings and go to Bluetooth, pair new device.
Choose “wireless remote”. The green light on the remote will remain on (not
blinking) to indicate a successful connection.
Inserting the mobile phone into the holder
Tilt the mobile phone underneath the top bracket and push upwards. Secure the phone into the bottom bracket.
Taking photos/recording video
While holding the handle, press the photo button to take a picture or start/stop video recording
Mounting to a tripod and taking pictures remotely
Screw the grip onto the top of any standard tripod. Remove the remote button
from the handle by sliding it forward.
You can take pictures or start/stop video up to 10m (33ft) away from the
mobile phone.
Replacing the battery on the remote control
- When the battery needs to be replaced the indicator LED will blink red
- Remove the remote control from the handle by sliding it forward
- Turn the remote over and slide the battery compartment off
- Replace the battery using a “2016 coin lithium battery”
Operational notes
- When the Bluetooth remote is paired with a mobile phone and there is no activity for 10 minutes the remote will go into sleep mode. Press the photo button one time to wake it and automatically reconnect to the mobile phone.
- When the Bluetooth remote is paired with a mobile phone and there is no activity for 20 minutes the remote will turn off. Press and hold the photo button for 3 seconds to reconnect to the mobile phone.
Questions? Problems?
Picked up the wrong item?Before returning to the Store, please give our
customer service team a chance to help.
email us at TechSupport@Mizco.com for a seamless and
speedy resolution.
Mizco International, Inc.
Cranford, New Jersey
All rights reserved.
DIGIPOWER is a registered trademark of Mizco International Inc.
WARRANTY INFORMATION FOR DIGIPOWER PRODUCTS, A DIVISION OF MIZCO
INTERNATIONAL, INC.
We warrant all Digipower branded products against defects in material and
workmanship for two years from the original date of purchase. At our option,
we shall repair or replace the defective unit covered by this warranty. Please
retain the dated sales receipt as evidence of the date of purchase in order to
obtain any warranty service. This warranty is void if the product has been
handled or used in any manner which is inconsistent with the instructions
accompanying the product or the intended use of the product. This warranty
does not cover any damage due to accident, misuse, abuse, or negligence. This
warranty does not extend to equipment used with the product. This warranty is
valid only if the product is used on a compatible device as specified on or
attached to the product package. To verify compatibility, please check the
product package for details or visit:
www.DigiPowerSolutions.com.
Repair or replacement, as provided under this warranty, is your exclusive
remedy. We shall not be liable for any incidental or consequential damages.
DigiPower hereby expressly disclaims any and all implied warranties of
merchantability and fitness for a particular purpose.
Some states/countries do not allow the exclusion or limitation of incidental
or consequential damages, so the above limitation or exclusion may not apply
to you.
Some states/countries do not allow limitations on implied warranties, so the
above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other
rights that vary from state to state and country to country.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
disposal
For disposal in countries outside of the European Union This symbol is only
valid in the European Union (EU). If you wish to discard this product please
contact your local authorities or dealer and ask for the correct method of
disposal.
This symbol means that the product cannot be disposed of with normal household
waste (2012/19/EU).
- old devices can be returned free of charge to suitable collection points.
- these are collected there professionally or prepared for reuse. Old appliances may contain harmful substances that can harm the environment and human health. The raw materials contained can contribute to environmental protection through their recycling.
- the deletion of personal data on the waste equipment to be disposed of must be carried out by the end user on his own responsibility.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>