RAVAK PDOP1 Pivot Shower Door Instruction Manual

: June 5, 2024
: RAVAK

Table of Contents

RAVAK PDOP1 Pivot Shower Door
ASSEMBLY INSTRUCTIONS
IS POSSIBLE TO FIX
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

RAVAK PDOP1 Pivot Shower Door

RAVAK-PDOP1-Pivot-Shower-Door-

ASSEMBLY INSTRUCTIONS

Content of the mounting package.

Turning pivot shower door one-part, two-part.
Level the fixing profile into a perpendicular line using a water level. Mark the location of the profiles clearly on the wall.
Encircle the holes for mounting.
Bore a hole and hammer in a wall plug 8 mm diameter. Beware of the electric lines, water and gas pipes under the plaster.
In the place where will be the entrance of the shower door, screw on the fixing profile on the wall using screws 4/40 mm.
Slide the second fixing profile onto the doorframe.
Slide the product into the profile, which is already mounted.
Level it as marked on the wall.
Stick the screws 4/40 mm through the pre-bored holes in the doorframe into the wall plugs and mount the fixing profile onto the wall.
Set the doorframe between the mounted profiles in the optimal position.
Close the mounting holes in the doorframe with the blind flanges 10/13 mm.
Apply a silicone sealant on the seating area of the shower body and the shower tray. Always fill the gap between the product and the shower tray only from the outside, fill the vertical gap by the wall in the same way. The areas prepared for filling must be dry, firm and clean.
Complete assembled product.
The handle is adjustable.
If necessary, it is possible to readjust the turning pivot shower door.
A,B…F

IMPORTANT!
When maintaining the shower bath, only wipe the painted parts, glass and plastic, using a fine cloth and normal household detergents. Never use abrasive pastes, solvents, acetones or similar substances. The manufacturer is not responsible for damage caused by inappropriate use, installation or maintenance of the product. The manufacturer is entitled to continuous innovation of the product. For all other information concerning the mounting, use and maintenance, ask your salesperson. We recommend the use of the RAVAK SERIES of specialty chemicals: RAVAK ANTI CALC CONDITIONER – is a preparation that perfectly renews and maintains all the qualities of the RAVAKANTICALC protective coating; RAVAK CLEANER – works to remove old and dried-on debris from glass surfaces, shower frames, enamel and acrylic bathtubs, washbasins and water taps; RAVAK DISINFECTANT – is a special preparation with considerable anti-bacterial and anti-fungal effects. Ecologically dispose of the packaging materials and after the service life of the radiator is finished, properly dispose of the radiator as well. The reusable parts of the packaging materials such as the carton, tape and PE foil can be reused again instead of recycling them. The non-recyclable parts of the packaging and later, the radiator itself should be disposed of in a safe and proper manner according to law. Recycle the metal parts of the radiator by taking it to the proper recycling area.