TOSHIBA 6157-001 AI Ultra Smart 1-Chip Video Camera User Manual

: June 5, 2024
: Toshiba

Table of Contents

TOSHIBA 6157-001 AI Ultra Smart 1-Chip Video Camera
Telecommunication regulatory statement
Electronic emission notices
Federal Communications Commission (FCC) statement
Australia and New Zealand Class A statement
European Union EMC Directive conformance statement
Camera Introduction
Key Component
Tips on Placement
Operation Frequency and Radiation Power
Antenna Specification
Read User Manual Online (PDF format)
Download This Manual (PDF format)

TOSHIBA 6157-001 AI Ultra Smart 1-Chip Video Camera

TOSHIBA 6157-001 AI Ultra Smart 1-Chip Video Camera PRODUCT
IMAGE

Telecommunication regulatory statement

This product is not intended to be connected directly or indirectly by any means whatsoever to interfaces of public telecommunications networks, nor is it intended to be used in a public services network.

Electronic emission notices

When you attach a monitor to the equipment, you must use the designated monitor cable and any interference suppression devices that are supplied with the monitor.

Federal Communications Commission (FCC) statement

Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.
Properly shielded and grounded cables and connectors must be used in or-der to meet FCC emission limits. Toshiba Global Commerce Solutions is not responsible for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
This device must accept any interference received, including interference that might cause undesired operation.

Industry Canada Class A emission compliance statement
This Class A digital apparatus complies with Canadian ICES-003.

Australia and New Zealand Class A statement

Attention : This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

European Union EMC Directive conformance statement

This product is in conformity with the protection requirements of EU Council Directive 2014/30/EU on the approximation of the laws of the Member States relating to electromagnetic compatibility. Toshiba Global Commerce Solutions cannot accept responsibility for any failure to satisfy the protection requirements resulting from a non-recommended modification of the product, including the fitting of non-Toshiba Global Commerce Solutions option cards.
This product has been tested and found to comply with the limits for Class A Information Technology Equipment according to CISPR 32/European Standard EN 55032. The limits for Class A equipment were derived for commercial and industrial environments to provide reasonable protection against interference with licensed communication equipment.
Attention : This is an EN 55032 Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.

Responsible manufacturer:

Toshiba Global Commerce Solutions 3901 South Miami Blvd.
Durham, NC 27703 USA

European Community contact:
Toshiba Global Commerce Solutions, Inc. Brand Manager – Europe, Middle East & Africa Z.1 Researchpark 160, 1731 Asse, Belgium
Tel:33-6845-35093
e-mail: cthery@toshibagcs.com

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is not possible.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Section 15.204(b) states that an approved “transmission system” must always be marketed as a complete system including the antenna.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:

This device may not cause interference.
This device must accept any interference, including interference that may cause undesired operation of the device.

This device is restricted to indoor use.

IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm be-tween the radiator & your body.

The Country Code Selection feature is disabled for products marketed in the US/Canada