Shenzhen Hengyehui WX-01 Car Wireless Charger Phone Holder User Manual
- June 5, 2024
- Shenzhen Hengyehui
Table of Contents
Hengshui WX-01 Car Wireless Charger Phone Holder
User Manual
Please read this operation
Instruction carefully and keep it properly before using this product.
Product Introduction
Thank you for purchasing and using this product!
In order to ensure that you can provide a better operating experience for your
mobile phone or electronic products.
| Applicable model | Compliance with QI standard cell phone. |
|---|---|
| Normal input | DC 5V/2A(max) |
| Quick input | DC 9V/1.67A(max) |
| Working frequency | 100-J205KHZ |
PS: The above information is based on real sample testing, it will be a little bit different for different products in different conditions.
Operation
|
---|---
1. Insert the car charger into the car charging port, and insert one end of
the data cable into the car charger.| 2. Please wipe the car dashboard
carefully with a damp cloth.
|
3. Press the air switch so that the suction cup is firmly attached to the
instrument panel.| 4. Replace with the air outlet bracket, and install the
bracket to the car air outlet.
6. Install the external magnetic sheet, use the positioning card to stick the
magnetic sheet to the appropriate position of the phone case, and install the
phone case.
Note
- Don’t squeeze or crash.
- Don t use the wireless charger in high temperatures, humidity, or corrosive environment, avoid damaging the circuit and avoid leakage.
- Take care of the children, to ensure that they will not play with the wireless charger as a toy, to avoid unnecessary accidents.
- Don t disassemble or throw into fire or water, to avoid causing a short circuit leakage.
- Don t close with a magnetic stripe or chip care(/D card, bank card, ect) to avoid leakage.
- please keep the distance at least 20cm between implantable medical devices (pacemakers, implantable cochlear, ect) and the wireless charger, to avoid potential interference with the medical device.
- No metal plate on the back of the phone, because it will stop the phone from charging.
- To ensure fast and safe charging, we select the QC2.0/QC3.0/standard car charger and the best four-core universal data cable, other nonstandard car chargers or cables will make the charging slow.
- If the car temperature inside is too high, the charging will become slow; with the cold wind from the air outlet, charing on the air outlet will be much better, with the hot wind from the air outlet, pls charge the mount on the dashboard.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with RF radiation exposure limits set forth for an
uncontrolled environment. This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
This device must operate with a minimum distance of 20 cm between the radiator
and user body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>